Peg-Perego Pliko P3 - Manuel (Page 13)

31• Grip the central handle and pull it upward
until it closes, as shown in the figure.
32• Verify the correct closing of the stroller
from the safety hook. The folded stroller
can stand upright.
TRANSPORT
33• The stroller can easily be carried (lock the
swivelling front wheels) by gripping the
central handle, as shown in the figure.
34• You can also use the side handle to carry
it, as shown in the figure.
REMOVABLE LINING
35• To remove the strollerʼs lining, loosen the
fasteners on the armrests as shown by
the arrows.
36• Unbutton the sack at the side, as shown
in the figure. Slip the leg divider on the
safety belt out from under the seat.
37• Unbutton the sack from the seat and slip
it off the footboard hooks. Slip the sack
off the top of the stroller.
GANCIOMATIC SYSTEM
The Ganciomatic System is the swift,
practical system that allows one to fasten
to the stroller, with Ganciomatic fasteners,
the car seat Primo Viaggio, which can be
bought separately and is also equipped with
Ganciomatic System. Primo Viaggio can be
detached from its base (which stays in the car)
and attached to the Ganciomatic fasteners of
the stroller to transport your child without
disturbing him/her.
STROLLER GANCIOMATIC HOOKS
38• To raise the Ganciomatic hooks on the
stroller, pull the sack up at the corners of
the seat and turn the two hooks upwards
until they click into place.
39• To lower the Ganciomatic hooks on the
stroller, pull the little lever outwards and
turn the hooks upwards at the same time,
as shown in the figure.
PLIKO P3 + PRIMO VIAGGIO CAR SEAT
40• To fasten the car seat to the stroller:
- set the brake on the stroller,
- remove the hood from the stroller,
- completely lower the backrest on the
stroller,
- raise the Ganciomatic hooks on the
stroller.
- Place the car seat, turned towards the
adult, on the stroller and push downward
until it clicks into place.
- Do not remove the front bar from the
stroller when attaching the car seat.
• See the userʼs manual for instructions
on how to detach the car seat from the
stroller.
holder, as shown in the figure. After
fastening the safety belt on your child,
detach it from the backrest to allow the
child more freedom of movement. The
buckle must remain below the child's
shoulders.
ADJUSTING THE FOOTBOARD
22• The footboard can be adjusted to
three different positions. To lower the
footboard, pull the two small levers
downward while lowering. To lift the
footboard, pull it up until it clicks into
place.
ADJUSTING THE BACKREST
23• The backrest can be reclined in four
positions. To lower the backrest, raise
the handle as you lower the backrest,
blocking it in the desired position. To
raise it, push the backrest upward.
SWIVELLING WHEELS
24• To make the front wheels swivel, push
down as shown in the figure. To fix the
wheels, pull up the lever.
ADJUSTING THE HANDLES
25• The height of the handles can be adjusted
in two positions. For the upper position,
press the button as you raise the handle.
To lower it, press the button as you lower
the handle.
FRONT BAR
26• The front bar can be opened on one side
only to make it easier for the child to
get into the stroller when he is older. To
open the bar, press the button under the
armrest while pulling the bar outwards.
27• To remove the front bar, press the two
buttons under the armrests while pulling
the bar outwards.
REAR LEDGE
28• The rear ledge helps overcome small rises
and can also be used to carry a second
child.
LOADING SEQUENCE
29• To use the stroller with two children,
brake the stroller, place the smaller child
in the seat and fasten the safety belt (1).
Grip the handles (2) and help the second
child climb onto the footrest (3). Never
leave your children unattended. Do not
allow the child to climb onto the rear
footrest when the stroller is empty.
CLOSING
Before closing the stroller, loosen the
braces if the hood is attached, and raise
the backrest if it is lowered.
30• The stroller can be closed with one hand:
pull first one lever up and then the other
until it releases.