Panasonic WV-CF324 - Manuel (Page 14)

14
3. Zoom and focus adjustment
At the same time for the pan and tilt adjust-
ments (Step 2), make zoom and focus
adjustments.
q Loosen the zoom lock lever and move
the lever between TELE and WIDE to
obtain the appropriate angle of view.
Tighten the zoom lock lever.
w Move the focus lever between FAR and
NEAR to make coarse adjustment of the
focus.
Note: To change the angle of view by
moving the zoom lock lever, also
move the focus lever to adjust the
focus.
e Press the AF switch on the side of the
camera.
The LED for AF lights up for approx. 10
sec. and the focus is automatically
adjusted.
Notes:
• The ABF function does not cover the full
focus range. Be sure to perform coarse
adjustments for the angle of view and
focus manually, and then press the AF
switch to activate the ABF function.
• Do not touch the lens while the LED for
AF stays lighted. Failure to observe this
may cause trouble.
• The AF switch may not adjust the focus
initially. In such a case, widen the aper-
ture by pointing the camera at a dark
subject.
w Rotate the tilting table to adjust the tilting
position of the camera. (Range: ±75 °)
• Since using a variable focal lens, it is
possible to change the angular field of
view.
• This lens can also be rotated in the
reverse direction, but the image azimuth
is reversed. In such a case, turn the pan-
ning table to the 180 ° side. Then, the
image azimuth is corrected.
• When used at an angle that is close to
horizontal, it must be noted that the
shadow of the dome cover may be pro-
jected.
e Rotate the azimuth adjuster to adjust the
azimuth angle of the image. (Range:
±100 °)
Variable tilt angle: ±75°
w Focus lever
q Zoom lock lever
NEAR
WIDE
FAR
TELE
TOP
LOCK
B.S
BLC
ALC ELC
D/N ON OFF AF
MONITOR
Panning
table lock
screw
CCW: – 140 °
CW: +180
°
: CCD up-side
Indication
Panning table