Panasonic WV-LD2000 - Manuel (Page 6)

6
PRECAUTIONS
• Refer all work related to the installation of this appa-
ratus to qualified service personnel or system
installers.
• Do not block the ventilation opening or slots on the
cover.
To prevent the apparatus from overheating, place it at
least 5 cm {2 inches} away from the wall.
• Do not drop metallic parts through slots.
This could permanently damage the apparatus. Turn
the power off immediately and contact qualified service
personnel for service.
• Do not attempt to disassemble the apparatus.
To prevent electric shock, do not remove screws or
covers.
There are no user-serviceable parts inside. Contact
qualified service personnel for maintenance.
• Do not strike or give a strong shock to the unit.
It may cause damage or allow water to enter the unit.
• Do not expose the apparatus to water or moisture.
Do not try to operate it in wet areas.
Take immediate action if the apparatus gets wet. Turn
the power off and refer servicing to qualified service
personnel. Moisture can damage the apparatus and
also cause electric shocks.
• Cleaning
Turn the power off when cleaning the unit. Otherwise it
may cause injuries.
Do not use strong or abrasive detergents when clean-
ing the apparatus body.
Use a dry cloth to clean the apparatus when it is dirty.
When the dirt is hard to remove, use a mild detergent
and wipe gently.
• Do not operate the apparatus beyond its specified
temperature, humidity, or power source ratings.
Use the apparatus under conditions where tempera-
tures are between 0 °C and + 40 °C {+32 °F to +104 °F},
and humidity below 90 %.
The input power source for this apparatus is 100 V to
240 V AC, 50/60 Hz.
* Supplied AC power cord supports 120 V AC only. To
use this product with larger power source, replace the
power cord.
• Clear a space of more than 5 cm {2 inches} from
both sides, the top, the bottom and the rear of the
units.
• Do not mount the monitor on places subject to con-
stant vibrations. That may cause trouble or damage.
• Use only the supplied power cord or AC adapter.
• The surface of the LCD Panel is applied by special
coating.
Do not point hard objects and wipe by abrasive materi-
al. It can cause scratches and damages on the LCD
screen.
• The LCD panel is made from a very precise technol-
ogy.
Some bright and dark spots may exist on the monitor
screen. It is operating normally if there are 99.99 %
active pixels.
• Image persistence may appear on the LCD after a
static image with strong contrast is continuously
displayed.
Such a phenomenon is caused by an LCD characteris-
tic. The persistent image will disappear after a period of
time.