Panasonic WV-LD2000 - Manuel (Page 18)

18
TROUBLESHOOTING
Check the following before requesting repair.
If a trouble cannot be corrected even after checking and trying remedy, contact your dealer.
Check if the power plug is properly connected to the AC outlet.
Power is not turned on.
"NO SIGNAL" appears on the
screen, and no picture is dis-
played.
"OUT OF RANGE" appears on
the screen, and no picture is dis-
played.
Picture display position is not
proper while the PC input signal
is being selected.
The power cord insulation is
damaged.
The power cord, plug and con-
nectors get hot during use.
The power cord gets hot when
bent or stretched.
–
Check if the DC plug of AC adapter is properly inserted into the
DC IN jack of this monitor.
–
Check if the power cord is properly inserted into the AC adapter. –
Check the cables are properly inserted into the connectors. 11, 13
Check if the cable connection is corresponding with the selected
input signal.
11, 13
When the PC input signal does not meet the standards of this
monitor, no picture is displayed. Check the specifications of con-
nected PC.
9, 15
Perform auto adjustment on the PC menu. If the picture display
position is not properly adjusted, perform manual adjustment.
15
The power cord, plug and connectors are worn out. If you contin-
ue to use it, a fire or an electric shock may occur.
Unplug the AC adapter immediately, and refer servicing to quali-
fied service personnel.
–
Reference
pages
Cause/solution Symptom