Panasonic WV-LD2000 - Manuel (Page 13)

13
Before operation, check the connections between monitors
and external devices (cameras, digital disk recorders, etc.)
(Refer to p. 11.)
1. Press the power button. The monitor will be powered
on, and the power indicator will light up in green.
2. Press the INPUT SELECT button.
Every pressing this button can change input signals as
follows.
The signal name will be displayed on the upper right
corner of screen for 3 seconds.
Notes:
• When no input signal is supplied to the monitor, "NO
SIGNAL" will be displayed on the screen.
"NO SIGNAL" will continue to be displayed until an input
signal is supplied.
• When the loss of input signal is detected due to cable
disconnection, etc., "VIDEO LOSS" will be displayed on
the screen.
"VIDEO LOSS" will continue to be displayed until a
cable is connected.
• When the PC input signal is selected and picture dis-
play position is not proper, perform the VGA output set-
ting for the connected PC.
POWER-ON
Signal name Input signal type
VIDEO A Composite video A
VIDEO B Composite video B
S-VIDEO S-video
PC PC (Analog RGB)
VIDEO A
VIDEO B/
S-VIDEO
PC