Polk Audio POWERED SUBWOOFER PSW505 - Manuel (Page 5)

ADJUSTING YOUR SYSTEM
SUBWOOFER ADJUSTMENTS
Your Powered Subwoofer offers a range of setting options. We recommend the following
settings as starting points, but the settings that are best for you depend upon your speak-
er placement, electronics and personal taste. After you've become familiar with what the
settings do, experiment with alternate options to find the method that works best for
your system setup. You'll find an informative article on “Subwoofer Positioning and
Adjustment” in the set up section at: www.polkaudio.com/education/article.php?id=19.
Note: When you set up your subwoofer for the first time, you will probably
have to make adjustments several times before you hear what you personally
like. Start with the volume at 50%.
AC POWER CONNECTION AND AUTO ON/OFF
Your PSW Series subwoofer features auto on/off circuitry, marked “auto”
on the power switch, which automatically turns your subwoofer on when
it senses a program signal. We recommend the “auto” setting if your
subwoofer is always receiving power (ie, if it’s plugged into a wall outlet).
When no signal is present, the circuit turns the subwoofer off after 15 minutes.
If you are concerned about the brief delay between when the music starts and
when the subwoofer turns on, simply leave your subwoofer in the “On” position.
You may want to leave your PSW system unplugged during extended periods
of non use, such as during a vacation.
FINE TUNING YOUR SUBWOOFER
• Volume—Adjust by ear using a wide variety of CDs and video sources.
Adjust for deep, powerful bass without “boominess.”
• Low Pass—Note: This control does not operate when the subwoofer
is connected with Method #1 (LFE Input). This control adjusts the frequency
range over which the subwoofer operates. When using smaller main speakers,
the upper range of the control will probably yield the best results. With larger
speakers, the lower end of the control range will probably sound best, but
always let your ear be the final judge. If male vocals sound “thin,” turn this
control up until the voice sounds rich but not “boomy.” If male vocals sound
too “thick” or “chesty,” turn this control down until the voice sounds natural.
• Phase Switch—Sit in your favorite listening position. Play music (not a movie)
with a walking bass line. We recommend playing jazz or country music. Now listen
carefully for the point at which the subwoofer transitions to your main speakers.
This is the crossover point, and this point should be below the frequency of a male
human voice. Whichever phase setting sounds louder or fuller at the subwoofer’s
crossover (transition) point is the optimum setting. Sometimes no difference
will be heard.
TECHNICAL ASSISTANCE AND SERVICE
If, after following these hook up directions, you experience difficulty, please double-
check all wire connections. Should you isolate the problem to the speaker, contact the
authorized Polk Audio dealer where you made your purchase, or call Polk Audio’s friendly
Customer Service Department at 1-800-377-7655 (calls from US or CAN only), (Outside
the US or CAN, 410-358-3600), 9am to 5:30pm EST, Monday through Friday. You may
also contact us via email: [email protected]. For more detailed hook up information
and manual updates, visit: www.polkaudio.com.
For recommended accessories (including speaker stands, brackets, accessories
and exclusive Polk Audio logowear), visit our Webstore: http://shop.polkaudio.com.
For specifications visit: www.polkaudio.com/home.
No sound coming from subwoofer
Subwoofer doesn’t sound right
Subwoofer has no power
If hookup is “Sub Out” to LFE, is your
receiver set to “Subwoofer—yes” If
hookup is via speaker wire, check that
the polarity of the wires is correct.
If hookup is “Sub Out” to LFE, is your
receiver set to “Subwoofer—yes” If
hookup is via speaker wire, check that
the polarity of the wires is correct.
Check outlet; check fuse after unplugging
the subwoofer.
TROUBLESHOOTING
Customer Service Hours of Operation: Monday-Friday, 9 AM -5:30 PM EST [email protected] 5
VOLUME
MIN MAX
LOW PASS
(Hz)
90
60 120
POWER
180º
0º
PHASE LINE IN
L
R
LFE IN
(FILTERED) (UNFILTERED)
STAND BY
ON
AUTO
REFER TO OWNER'S
MANUAL FOR PROPER
INPUT CHOICE.
POWER
S
P
E
A
K
E
R
IN
–
+
+
–
–
+
+
–
S
P
E
A
K
E
R
O
U
T
LEFT RIGHT
120V ~ 60HZ 3A
3.15A 250V
Caution: For continued protection against risk of fire,
replace only with same type fuse and rating.
Attention: Utiliser un fusible de rechange
de meme type et caliber.
t h e s p e a k e r s p e c i a l i s t s ®
Figure 4: PSW505