Pioneer PDP-60MXE20 - Manuel (Page 15)

11
En
English
Installation and Connections
Power cord connection
Connect the power cord after all component connections
have been completed.
AC IN
2
1 Connect the power cord to this unit.
2 Plug the power cord into a power outlet.
CAUTION
÷ Use only the power cord provided.
÷ For the Plasma Display, use a three-core power cord with a
ground terminal.
Always be sure to connect the power cord to a three-pronged
grounded outlet and make sure that the cord is properly
grounded. If you use a power source converter plug, use an
outlet with a ground terminal and screw down the ground line.
NO!
Do not use a power supply voltage other than that indicated (AC
100 V to 240 V, 50 Hz/60 Hz) as this may cause fire or electric
shock.
Attaching the ferrite cores
Attach the accessory ferrite core to the end of the power
cord as shown in the accompanying illustration. Use the
provided cable tie to prevent the ferrite core from slipping
on the cable.
If you do not do this, this monitor will not conform to
mandatory CE or C-Tick standards.
Ferrite core
Cable tie
AC power cord
To power
outlet
As close as possible
To AC IN
Note
Regarding the audio cable, attach the supplied ferrite core.
Wind the audio cable (not supplied) around the ferrite core once,
and then fasten the catch.
If you do not do this, this monitor will not conform to mandatory
CE or C-Tick standards.
Audio cable (not supplied)
Ferrite core