Philips gc2530 - Manuel (Page 4)

Solution
Check the mains cord, the
plug and the wall socket.
Set the temperature dial
to the required position.
Fill the water tank (see
chapter 'Preparing for use',
section 'Filling the water
tank').
Set the steam position to
Á or È (see chapter
'Using the appliance',
section 'Steam ironing').
Set the temperature dial
to a position in the steam
area (
2 to MAX). Put
the iron on its heel and
wait until the temperature
light has gone out before
you start ironing.
Continue ironing in
horizontal position and
wait a while before using
the shot-of-steam function
again.
Set the temperature dial
to a position in the steam
area (
2 to MAX). Put
the iron on its heel and
wait until the temperature
light has gone out before
you start ironing.
Use the Calc-Clean
function a few times (see
chapter 'Cleaning and
maintenance', section
'Calc-Clean function').
Pick the iron up or move it
slightly to deactivate the
automatic shut-off
function. The red light
stops blinking.
Press onto the cap until
you hear a click.
Set the temperature dial
to a position in the steam
area (
2 to MAX). Put
the iron on its heel and
wait until the temperature
light has gone out before
you start ironing.
Empty the water tank and
set the steam control to
position
O after use. Store
the iron on its heel.
Possible cause
There is a connection
problem.
The temperature dial has
been set to MIN.
There is not enough water
in the water tank.
The steam control has
been set to position
O.
The soleplate is not hot
enough and/or the drip
stop function (specific
types only) has been
activated.
The shot-of-steam
function has been used
too often within a very
short period.
The soleplate is not hot
enough.
Hard water forms flakes
inside the soleplate.
The automatic shut-off
function has been
activated (see chapter
'Features', section
'Automatic shut-off').
The cap of the filling
opening has not been
closed properly.
(GC2640/GC2620/
GC2530/GC2520
/GC2510 only).The set
temperature is too low for
steam ironing.
The iron has been put in
horizontal position while
there was still water in the
water tank.
Problem
The iron is plugged in but
the soleplate is cold.
No steam.
No shot of steam or no
vertical shot of steam
(specific types only).
Flakes and impurities come
out of the soleplate during
ironing.
The red light blinks
(GC2560 only).
There are water droplets
on the fabric.
There are water droplets
on the fabric.
Water drips out of the
soleplate after the iron has
cooled down or has been
stored.
4239 000 61482
4/13