KITCHENAID W10185043A - Manuel (Page 6)

6
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
OPTION SELECTIONS
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
For best drying results, dry
dishes with heat. This option with the use of rinse aid will provide the best
drying performance. All cycles, except Quick
Cleanup and Rinse
Only. Automatic with all
wash cycles unless you
turn it off.
To sanitize your dishes and
glassware in accordance
with NSF/ANSI Standard
184 for Residential
Dishwashers. Raises the water temperature in the final rinse to
approximately 155°F (68°C). This high temperature rinse
sanitizes your dishes and glassware in accordance with
NSF/ANSI Standard 184 for Residential Dishwashers.
Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to the
cycle.
Sensor Wash, Heavy
Duty and Normal Wash.
Only these sanitization
cycles have been
designed to meet the
NSF/ANSI
requirements.
Loads containing tough,
baked-on food. Increases the target water temperature during the wash
portions of the cycle.
Adds heat, wash time and water to the cycle.
Sensor Wash, Heavy
Duty or Normal Wash
To run your dishwasher at
a later time or during off-
peak hours. Delays the start of a cycle up to 4 hours.
Select a wash cycle and options. Press 4 Hour Delay. Press
START/RESUME. Close the drawer firmly.
All cycles, except Rinse
Only
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle. To turn on Lock, press and hold ProDry for at least
3 seconds.
To turn off Lock, press and hold ProDry for at least
3 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher drawer can be opened while the
controls are locked.
Anytime
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume a
wash cycle If the drawer is opened during a cycle, a delay, or the power is interrupted, the Start/Resume
indicator flashes. To restart the drawer, open the drawer, press Start/Resume and close the
drawer firmly within 4 seconds./
To cancel wash
cycle Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely. If the Cancel button is pressed a second time, the drawer will turn off.
To follow the
progress and status
of your dishwasher
cycle Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized indicator
glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the
cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required
temperature. The light goes off when you open and close the drawer or press CANCEL.
The rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled.