KITCHENAID Pro Line Front-Loading Automatic Dishwasher - Manuel (Page 4)

4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
Tools needed for installation
Parts supplied
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number on the cover or in the “Assistance or Service” section.
Options
A pedestal may be purchased separately for this washer. This
pedestal will add about 11" (27.9 cm) to the height of your
washer for a total vertical height of approximately 53" (134.6 cm).
Optional pedestal
To order, call the dealer from whom you purchased your washer
or refer to the “Assistance or Service” section of this manual. Ask
for Model Number LAV2701RSS.
Location Requirements
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer “walk.”
Your washer can be installed under a custom counter, in a
basement, laundry room, closet, or recessed area. See “Drain
System.”
IMPORTANT: Do not install or store the washer where it will be
exposed to the weather.
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
■ A water heater set to deliver 120°F (49°C) water to the
washer.
■ A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
■ Hot and cold water faucets located within 5 ft (1.5 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
■ A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on carpeting is not
recommended.
■ A sturdy floor to support the washer with a total weight
(washer, water and load) of 550 lbs (249 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures. See “Washer Care” for winterizing information.
■ Pliers that open to
1
⁹⁄₁₆" (3.95 cm)
■ Flashlight (optional)
■ Adjustable or open end
wrenches, 13 mm and
⁹⁄₁₆" (14 mm)
■ #3 Phillips screwdriver
■ Ruler or measuring tape
■ Wood block
■ Level
A. Door handle
B. Door handle washers (2)
C. Door handle screws (2)
D. Cable tie
E. Transport bolt hole plug (4)
F. Inlet hose (2)
If You Have You Will Need to Buy
Laundry tub or
standpipe taller
than 96" (2.4 m) Sump pump system (if not already
available)
Overhead sewer Standard 20 gal. (76 L), 30" (76.2 cm) tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number 285834;
additional drain hose Part
Number 8318155; and connector kit, Part
Number 285835
Drain hose too
short 4 ft drain hose extension kit, Part
Number 285863
Water faucets
beyond reach of fill
hoses 2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008
A
B
C
E
F
D