KITCHENAID Overlay Model Refrigerator - Manuel (Page 4)

4
Overlay Panel—Rear View
Create the custom overlay door panel using the dimensions
shown. The rear view of overlay panel shows right-hand hinge.
Mirror the image for left-hand hinges. See “Pivot Plate Relief” for
additional dimensions.
Pivot Plate Relief
1. Route the top and back of the overlay panel to create the
pivot plate relief as shown.
2. Drill two screw holes in the back of the pivot plate relief as
shown.
Door Hinge Holes
1. Using a #16 drill bit, drill an ¹¹⁄₁₆" (1.75 cm) deep hole into the
top of the overlay panel for the top hinge pin as shown.
Top View
2. Drill a
⁵⁄₁₆" diam x ¹⁄₄" deep (7.94 mm x 6.35 mm) hole in the
bottom of the overlay panel for the bottom hinge as shown.
NOTE: CHAMFER
¹⁄₃₂" (.79 mm) x 45°.
Bottom View
Location Requirements
To ensure proper ventilation for your refrigerator, allow for a ¹/₄"
(0.64 cm) space on each side and at the top. When installing your
refrigerator next to a fixed wall, leave 2
¹⁄₂" (6.35 cm) minimum
clearance on each side to allow for the door to swing open.
A. Pivot plate location
Side View Back View
A.
⁵⁄₁₆
" diam. x
¹⁄₂
" deep
(7.94 mm x 1.25 cm)
A
23
³⁄₄
"
(60.33 cm)
29
⁷⁄₈
"
(75.88 cm)
¹⁄₈
"
(3.18 mm)
R
¹⁄₃₂
"
(0.79 mm)
¹³⁄₁₆
"
(2.06 cm)
R
¹⁄₈
"
(3.18 mm)
A ¹⁄₈
"
(3.18 mm)
¹³⁄₁₆
"
(2.06 cm)
⁷⁄₁₆
"
(11.11 mm)
¹³⁄₃₂
"
(10.32 mm)
1
¹⁷⁄₃₂
"
(3.89 cm)
³⁄₄
"
(1.91 cm)
A. Top hinge-pin hole
A. Bottom hinge-pin hole
¹³⁄₃₂
"
(10.32 mm)
³⁄₈
"
(9.53 mm)
A
³⁄₈
"
(9.53 mm)
A
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.