KITCHENAID 2200139A - Manuel (Page 11)

11
Base Grille
To remove the base grille:
1. Open both refrigerator doors.
2. Place hands along the ends of the grille, with your
thumbs along the top. Push in with your thumbs and
pull up on the bottom.
NOTE: Be sure to refasten the Tech Sheet behind the base
grille after cleaning.
To replace the grille:
1. Open the doors.
2. Line up the grille support tabs with the metal clips.
3. Push the grille firmly to snap it into place.
Door Closing
Your refrigerator has 2 front adjustable rollers — one on the
right and one on the left. If your refrigerator seems
unsteady or you want the doors to close easier, adjust the
refrigerator's tilt using the instructions below:
1. Plug in refrigerator.
2. Move the refrigerator into its final position.
3. Remove the base grille (see “Base Grille” earlier in this
section). The two leveling screws are part of the front
roller assemblies which are at the base of the
refrigerator on either side.
4. Use a screwdriver to adjust the leveling screws. Turn
the leveling screw to the right to raise that side of the
refrigerator or turn the leveling screw to the left to lower
that side. It may take several turns of the leveling
screws to adjust the tilt of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws
and rollers. This makes it easier to adjust the screws.
5. Open both doors again and check to make sure that
they close as easily as you like. If not, tilt the
refrigerator slightly more to the rear by turning both
leveling screws to the right. It may take several more
turns, and you should turn both leveling screws the
same amount.
6. Replace the base grille.
25 and 27 cu. ft. 25 and 27 cu. ft.
Freezer door Refrigerator door
panel dimensions panel dimensions
20 7/16 "
14 15/16 "
28 1/2 "
63 3/8 "
TOP VIEW
3/4"
1/4"
5/16"
5/16"
14 15/16 "
(6.35 mm)
(7.93 mm)
(51.91 cm)
(37.94 cm)
(37.94 cm)
(72.4 cm)
(7.93 mm)
1/4"
(6.35 mm)
1/4"
(6.35 mm)
5/16"
(7.93 mm)
(160.97 cm)
1/4"
(6.35 mm)
(19.05 mm)
3 1/4"
(82.55 mm min.)
19 11/16 "
(50.01 cm)
5/16"
(7.93 mm)
1/4"
(6.35 mm)
3/4" min.
(19.05 mm min.)
TOP VIEW
3/4" min.
3/4"
1/4"
(19.05 mm min.) (19.05 mm)
(6.35 mm)
3 1/4"
(82.55 mm min.)