KITCHENAID Cabinet Depth Side-by-Side Refrigerator - Manuel (Page 8)

8
6. Replace the hinge side trims by inserting the notched end
under the top trim first.
7. Tighten the two top trim screws.
1. Side Trims
2. Top Trim Screws
3. Door Panels
4. Filler Panels
Base Grille
Style 1:
To remove the base grille:
1. Open the refrigerator and freezer doors 90°.
2. Remove screws from the base grille using a Phillips
screwdriver.
Note: Do Not Remove Tech Sheet that is fastened behind the
base grille.
To replace the base grille:
1. Open the refrigerator and freezer doors to 90°.
2. Position the base grille in front of the refrigerator and replace
the screws.
Style 2:
To remove the base grille:
1. Open the refrigerator and freezer doors to 90°.
2. Grasp the grille with both hands.
3. Lift up and tilt the top of the grille toward you.
NOTE: Do not remove the Tech Sheet that is fastened behind the
grille.
To replace the base grille:
1. Open the refrigerator and freezer doors to 90°.
2. Place the lower clips in the openings in the metal panel.
3. Roll the grille up toward the refrigerator until it snaps into
place.
Leveling Your Refrigerator
Your refrigerator has a front and rear roller at the base of the
product on each side. All four rollers can be adjusted from the
front of the product. If your refrigerator seems unsteady or you
want the doors to close easier, adjust the refrigerator's tilt using
the instructions below:
1. Check the installation location to be sure that you have the
proper clearance for the refrigerator. (See the “Space
Requirements” section.)
2. Plug into a grounded 3 prong outlet.
3. Move the refrigerator into its final position.
4. Open the refrigerator and freezer doors to locate the leveling
bolts at the left and right of the refrigerator base. If your
refrigerator has a base grille, remove it (see “Base Grille”
earlier in this section).
NOTE: The top bolt will adjust the rear of the refrigerator, and
the bottom bolt will adjust the front of the refrigerator.
1. Rear Leveling Bolt
2. Front Leveling Bolt
5. Use a ¹⁄₂ in. (12.70 mm) socket wrench to adjust the leveling
bolts. Turn the leveling bolt to the right to raise that side of the
refrigerator or turn the leveling bolt to the left to lower that
side. It may take several turns of the leveling bolts to adjust
the tilt of the refrigerator.
NOTE: Be careful not to unscrew the leveling bolts too much
when lowering the refrigerator. The bolt head will start to
come away from the refrigerator when in the lowest position.
If the screw does come out of the rear roller bracket, the
compartment access cover on the back of the refrigerator will
have to be removed to reinstall the bolt.