Kustom DE200HD Manuel d'utilisation
Page 4
4
Direct Output (1
)
This XLR jack is used to connect the amplifier to a mixer or other line level amplifier. The output
for this jack is post EQ, so the EQ setting will be reflected on this output.
CD/Tape Input (2
)
This stereo 1/4” jack will allow you to plug in a CD player or other line level source into the
amplifier. This can be used to practice with the music. The left and right signals are combined into
a mono signal. Note: To adjust the volume of the source, adjust the output volume of the device.
Bass Input (3
)
This 1/4” jack is used to connect your bass guitar to the amplifier. It is intended for bass, but will
accept other high-impedance instruments as well.
Gain Control (4
)
This control is used to match the output level of your bass to the input of this amplifier. If the Clip
LED (5
) lights, turn the control counter clockwise until the LED turns off. Then adjust the Volume
Control (6
) to desired overall volume.
Clip Indicator (5
)
This LED indicates if the input is too “hot” for the amplifier. If this lights, turn the Gain Control (4
)
counter clockwise until the LED turns off. Then adjust the Volume Control (6
) to desired volume.
Volume Control (6
)
This control adjusts the overall volume of the amplifier. The Gain Control (4
) works in conjunction
with this knob.
Notch Frequency Control (7
)
This control is a wide band sweep that ranges from 40 to 800 Hz. It is set to -12db and used to
help you fine tune your sound. It is effective for removing unwanted overtones.
Equalizer Section (8
)
This is an active equalizer used to adjust your overall tone to a desired setting. Turning them fully
counterclockwise will cut that frequency by -12db. Turning them fully clockwise will boost that
frequency by +12db. The center frequencies are labeled above the knobs. Note: The 5K control
essentially works as a horn volume control.
Power Indicator (9
)
This indicator will light when the AC power is applied to the amplifier.
Power Switch (0
)
This switch is used to apply AC power to the amplifier.