KITCHENAID 2006136 - Manuel (Page 14)

14
Dispenser/ice maker operating tips
CAUSE SOLUTION
Freezer door open Close the freezer door.
Ice bin not properly installed Make sure ice bin is pushed in all the way.
Wrong ice in bin Use only crescents from ice maker. Shake ice bin
occasionally to keep cubes separated and to obtain
increased storage capacity.
Dispenser not used for Dump old ice and make a new supply.
extended periods of time,
causing ice cubes to melt
together
Ice dispenser bar held Wait about three minutes for the dispenser motor to reset.
in too long Large amounts of ice should be taken from the bin,
not through the dispenser.
Lock Out has been chosen Turn Lock Out off.
Low water pressure Call local utility company.
Ice attracts airborne odors; Dump old ice and make a new supply; store excess
old ice ice in a covered container.
Water quality For best results, avoid connecting ice maker to a
softened water supply. If softened water supply cannot
be avoided, make sure the water softener is well
maintained and operating properly.
Foods not properly wrapped Wrap foods properly in airtight and moisture-proof
materials. See page 20.
Ice bin and freezer may need Clean freezer and ice bin. See “Cleaning the
cleaning
refrigerator” on page 17 for instructions.
Plumbing to ice maker Follow Installation Instructions for proper ice maker
water supply hookup.
New ice maker The first few batches of ice from a new ice maker may
have an off-taste. Dump this ice and make a new supply.
PROBLEM
Dispensers won’t work
Ice dispenser won’t work
Off-taste or odor in ice
Base grille
To remove:
1. Remove one screw at each end of the base grille.
2. Remove base grille.
3. Replace in reverse order.