KITCHENAID KDRP487 - Manuel (Page 14)

14
Home Canning
When canning for long periods, alternate the use of surface
burners between batches. This allows time for the most recently
used areas to cool.
■ Center the canner on the grate.
■ Do not place canner on 2 surface burners at the same time.
■ For more information, contact your local agricultural
department. Companies that manufacture home canning
products can also offer assistance.
Cookware
IMPORTANT: Do not leave empty cookware on a hot surface
cooking area, element or surface burner.
Ideal cookware should have a flat bottom, straight sides, and a
well-fitting lid and the material should be of medium-to-heavy
thickness.
Rough finishes may scratch the cooktop. Aluminum and copper
may be used as a core or base in cookware. However, when used
as a base they can leave permanent marks on the cooktop or
grates.
Cookware material is a factor in how quickly and evenly heat is
transferred, which affects cooking results. A nonstick finish has
the same characteristics as its base material. For example,
aluminum cookware with a nonstick finish will take on the
properties of aluminum.
Use the following chart as a guide for cookware material
characteristics.
ELECTRONIC OVEN
CONTROL
First Use/Power Interruption
When power is first supplied to the appliance, “PF” will appear.
If “PF” appears at any other time, a power failure has occurred.
Turn the SELECTOR control knob to the RESET position, press
the ENTER button, and follow the clock setting instructions in the
“Clock” section.
Selector and Set Control Knobs
All cooking functions are set with the SELECTOR control knob.
The selected function will automatically begin with current
settings after 10 seconds if other settings are not changed. Once
a cycle is complete, turn the SELECTOR control knob to the
RESET position to select a new function.
All temperature or time adjustments are set with the SET control
knob. All temperature adjustments are displayed in 5°F (3°C)
increments.
The speed with which the knob is turned is reflected on the
display.
Enter and Cancel
The ENTER button begins any oven function.
The CANCEL button stops any oven function except for the
Clock/Time of Day. After canceling an operation, “End” will be
displayed to show the function was canceled.
The cooling fan might continue operating after a function has
ended, but will shut off automatically when the oven has cooled.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
1. Turn the SELECTOR knob to the RESET position.
2. Press the ENTER button until the display shows “12:00” and
the CLOCK indicator is blinking.
3. Turn the SET knob to set the time of day.
4. Press the ENTER button to accept time on display.
To Change: Repeat steps 2-4 to change time of day to the display.
COOKWARE CHARACTERISTICS
Aluminum ■ Heats quickly and evenly.
■ Suitable for all types of cooking.
■ Medium or heavy thickness is best for
most cooking tasks.
Cast iron ■ Heats slowly and evenly.
■ Good for browning and frying.
■ Maintains heat for slow cooking.
Ceramic or
Ceramic glass ■ Follow manufacturer’s instructions.
■ Heats slowly, but unevenly.
■ Ideal results on low to medium heat
settings.
Copper ■ Heats very quickly and evenly.
Earthenware ■ Follow manufacturer’s instructions.
■ Use on low heat settings.
Porcelain
enamel-on-
steel or cast
iron ■ See stainless steel or cast iron.
Stainless steel ■ Heats quickly, but unevenly.
■ A core or base of aluminum or copper
on stainless steel provides even
heating.
A. Display
B. Selector control knob
C. Set control knob
A
B C