KITCHENAID KSBN220PSS - Manuel (Page 4)

4
Product Dimensions
Enclosure Cutout Dimensions
3-1/2"
(8.9 cm)
1/2"
male NPT
26" (66.0 cm)
25-1/2" (64.8 cm)
Enclosure and clearance dimensions that are shown must be used.
Given dimensions provide required clearances.
The installation of this Side Burner must conform with the current
standards CSA-Z21.58a-1998*, or with local codes.
The side burner drops into the enclosure opening and is supported by
its side flanges. No bottom support is needed.
Copies of the standards listed may
be obtained from:
* CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio 44131-5575
22-1/2"
(57.2 cm)
12-1/8"
(30.8 cm)
2-1/4"
(5.7 cm)
12" (30.5 cm)
minimum to grill
or any accessory
counter or support surfaces
must be level
35-1/2"
(90.2 cm)
12"
(30.5 cm)
10-5/8"
(27.0 cm)
Tools and parts
13-1/4"
(33.7 cm)
21-3/8" (54.3 cm)
7-1/8"
(18.1 cm)
gas line
location at
rear of side
burner
Parts supplied
• convertible regulator set for 4" W.C.
natural gas
Tools needed:
• level
• small flat-blade screwdriver
• flat-blade screwdriver
• Phillips screwdriver
• tape measure or ruler
• slip-joint pliers
• pipe wrench
Parts needed:
• gas line shutoff valve
• 1/2" male pipe thread nipple for
connection to pressure regulator
• L.P. gas-resistant pipe-joint compound
• AGA or CSA design-certified outdoor
flexible stainless steel appliance
connector
[4-5 ft. (1.2-1.5 m)] or rigid gas supply
line as needed
• non-corrosive leak detection solution