SVAT Electronics qxd600 - Manuel (Page 6)

w w w . s v a t . c o m
Troubleshooting
Please read this manual carefully before using the wired line. If you have
any difficulties using this unit, please consult the following checklist.
No picture or sound
1. Check and make sure that the power adapters are properly
attached to the units.
2. Make sure that all cables are connected to the proper colours and
are snug with the jacks.
3. Make sure that the camera and the monitor are both on the same
channel.
The Image is fuzzy
1. Rotate the lens with your fingers either clockwise or counter-clockwise
until the image is where you want it to be.
Care and maintenance
• Keep all parts and accessories out of reach of young children.
• Do not attempt to open the case. Non-expert handling of the device
may damage it.
• Do not use or store in dusty, dirty or moist areas. This is an indoor unit.
• Do not store in hot areas. High temperatures can shorten the life of
electronic devices and warp or melt certain plastics.
• Do not store in very cold areas. When the system warms up
(to its normal temperature), moisture can form inside the case, which
may damage electronic circuit boards.
• Do not drop, knock, or shake it. Rough handling can break internal
circuit boards.
• Do not use harsh chemicals, cleaning solvents, or strong detergents
when cleaning.
• Operate this product using only the power supply included with it or
provided as an accessory.
Specifications
Camera (ClearVu 60)
Image sensor . . . . . . . . . . . . . . . . .1/4 CMOS B/W lens
Resolution . . . . . . . . . . . . . . . . . . .330 TV Lines
Lens . . . . . . . . . . . . . . . . . . . . . . . .3.6 mm
Camera Power Consumption . . .12V DC
Signal/Noise Ratio . . . . . . . . . . . . .48 dB
Monitor (5.5” B/W)
Monitor Power Supply . . . . . . . . . .13.5V DC
Power Consumption . . . . . . . . . . .<15W
Screen Size . . . . . . . . . . . . . . . . . .5.5”
Operating Temperature . . . . . . . .32
o F to 104 o F
6