Samsung M1927N - Manuel (Page 55)

7
GB
Installing Your Microwave oven
Place the oven on a flat, level surface that strong enough to safely bear
the weight of the oven.
☛
Never block the air vents as the oven may overheat and
automatically switch itself off. It will remain inoperable until it has
cooled sufficiently.
☛
For your personal safety, plug the cable into a 3-pin, 230 Volt,
50Hz, AC earthed socket. If the power cable of this appliance is
damaged, it must be replaced by a special cable (I-SHENG
SP022, KDK KKP4819D, EUROELECTRIC 3410, SAMIL SP-
106B, MOONSUNG EP-48E, HIGH PROJECT H.P 3). Contact
your local dealer to have it replaced. The power cable of ISRAEL
is PENCON(ZD16A), S/AFRICA APEX LEADS SA16 and
NIGERIA, GHANA, KENYA and U.A.E is PENCON(UD13A1).
☛
Do not install the microwave oven in hot or damp surroundings
like next to a traditional oven or radiator. The power supply
specifications of the oven must be respected and any extension
cable used must be of the same standard as the power cable
supplied with the oven. Wipe the interior and the door seal with a
damp cloth before using your microwave oven for the first time.
Setting the Time(M1927N)
Your microwave oven has an inbuilt clock. The time can be displayed
in either the 24-hour or 12-hour notation. You must set the clock:
• When you first install your microwave oven
• After a power failure
✉
Do not forget to reset the clock when you switch to and from
summer or winter time.
1. When you install your oven, make sure there is adequate
ventilation for your oven by leaving at least 10 cm (4
inches) of space behind and, on the sides of the oven
and 20 cm (8 inches) of space above.
2. Remove all packing materials inside the oven.
Install the roller ring and turntable.
Check that the turntable rotates freely.
3. This microwave oven has to be positioned so that plug is
accessible.
20cm
above
10cm
behind
10cm
of the side
1. To display the time in the..Then press the button...
24-hour notation Once
12-hour notation Twice
2. Turn the Time/Weight( ) dial to set the hour.
3. Press the button.
4. Turn the Time/Weight( ) dial to set the minute.
5. Press the button.
M1927n_17N_GB.fm Page 7 Monday, April 23, 2001 6:28 PM