Invacare 6795 - Manuel (Page 7)

Part No. 1118394 7 Rehab Shower Commode Chair
LABEL LOCATIONS
LABEL LOCATIONS
LABEL LOCATIONS
NOTE: The weight capacity
label is located on the back
of the cross-member.
IMPORTANT NOTICE
The wheel locks on this wheelchair have been
pre-set at the factory to comply with the
Veterans Administration functional Standard
8320.01 of the Federal Register, paragraph
3.2.4.5.3. If these wheel locks do not meet
your needs, follow instructions below.
! CAUTION
Any wheel lock adjustments should embed
wheel lock shoe at least 1/8" into tire when
locked (3/16" on pneumatic tires).
INSTRUCTIONS FOR WHEEL
LOCK ADJUSTMENTS
1.Loosen wheel lock mounting fastener,
which runs through mounting bracket and
frame.
2.Slide clamp toward rear wheel until wheel
lock shoe is embedded into tire material at
least 1/8" when handle is engaged to the
lock position (3/16" for pneumatic tires).
3.Tighten mounting fastener to secure
mounting bracket in desired location and
recheck lock shoe embedding.
4.Inspect for correct locking action BEFORE
actual use.
P/N 1114837 REV A