Invacare 6795 - Manuel (Page 23)

Part No. 1118394 23 Rehab Shower Commode Chair
SECTION 7 FRONT RIGGINGS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may result.
REMOVING/INSTALLING/ADJUSTING SWINGAWAY
FOOTREST ASSEMBLY (FIGURE 1)
REMOVING
1. Lift footrest assembly to disengage
from shower commode chair
frame.
2. Remove footrest assembly from
chair frame.
INSTALLING
1. Place the top of the footrest assem-
bly into Rehab Shower Commode
chair frame.
2. Slide and push down to lock in
place.
ADJUSTING
1. Lift footrest assembly enough to disengage from inner pin, but not enough to totally
remove from Rehab Shower Commode chair frame.
2. Swing the footrest to the outside of the Rehab Shower Commode chair.
3. Repeat the procedure for the other footrest assembly.
FOOTPLATE HEIGHT ADJUSTMENT
NOTE: Footplates adjust up and down by lifting up on the footplate until footplate adjustment pin
disengages from hole.
1. Lift front of footplate up until footplate adjustment pin disengages from hole.
2. Slide footplate to alternate footplate adjustment height.
3. Push down on front of footplate until footplate adjustment pin engages into desired
pin hole.
Section 7 - Front Riggings - includes the following:
Removing/Installing/Adjusting Swingaway Footrest Assembly
Footplate Height Adjustment
Replacing Heel Loops
FRONT
RIGGINGS
FIGURE 1 - REMOVING/INSTALLING/
ADJUSTING SWINGAWAY
FOOTREST ASSEMBLY
Rehab
Shower
Commode
Chair Frame
Footplate
Footplate
Adjustment Pin
Footrest
Footrest
Assembly