Insignia NS-R20C - Manuel (Page 7)

5
Insignia NS-R20C Round Tube TV
www.insignia-products.com
Connecting an S-Video device
To connect an S-Video device:
1 Plug an S-Video cable into the S-VIDEO jack
on the back of your TV, then plug the other
end of the cable into the S-VIDEO OUT jack
on the S-Video device.
2 Plug the left and right audio cables into the
AUDIO L and AUDIO R jacks on the back of
your TV, then plug the other ends into the left
and right AUDIO OUT jacks on the device.
Using your TV
Turning your TV on and off
To turn your TV on and off:
1 Plug the power cord into a power outlet.
2 Press POWER.
Selecting the TV signal source
To select the TV signal source:
1 Press MENU. The on-screen display (OSD)
opens.
2 Press MENU one or more times to highlight
Tuning.
3 Press CH or CH to highlight
SOURCE.
4 Press VOL or VOL on the remote
control or VOL or VOL on the front of
your TV to select AIR (outside antenna) or
CABLE (cable TV).
Memorizing channels
When you memorize channels, your TV scans
for available channels in your viewing area and
stores the channel information in memory.
To memorize channels:
1 Press MENU. The on-screen display (OSD)
opens.
2 Press MENU one or more times to highlight
Tuning.
3 Press CH or CH to highlight AUTO
SEARCH.
4 Press VOL or VOL on the remote
control or VOL or VOL on the front of
your TV to start scanning for channels. This
process may take several minutes.
5 If you want to stop scanning, press MENU.
Deleting a memorized channel
If you to skip a channel when you use a channel
buttons, you can delete the channel from
memory.
To delete a memorized channel:
1 Tune to the channel you want to delete.
2 Press MENU. The on-screen display (OSD)
opens.
3 Press MENU one or more times to highlight
Tuning.
4 Press CH or CH to highlight DELETE
CH.
5 Press VOL or VOL on the remote
control or VOL or VOL on the front of
your TV to select YES.
Changing channels
To change channels:
• Press CH or CH .
Or, press the number buttons to enter the
channel number. For example, to select
channel 12, press 1 then press 2. The
channel changes in about 1.5 seconds. If you
press 0 before you press 1, the channel
changes immediately.
Adjusting the picture
To adjust the picture:
1 Press MENU. The on-screen display (OSD)
opens.
2 Press MENU one or more times to highlight
Picture.
3 Press CH or CH to highlight the option
you want to adjust. You can select
BRIGHTNESS, CONTRAST, COLOR,
SHARPNESS, TINT, or COLOR TEMP.
Note
The power indicator turns off when your TV is
active.
The power indicator turns red when your TV is in
standby mode.
If your TV has a blue screen or a screen saver
displayed, your TV goes into standby mode after
five minutes.
S-Video device
To L audio out (white)
To R audio out (red)
To S-Video out
L AUDIO (white)
R AUDIO (red)
S-VIDEO
Audio cable