Appendix, To attach a wall mount bracket to your tv, Specifications – Insignia NS-LCD15F Manuel d'utilisation

Page 13: Legal notices, Fcc part 15, Modifications, Cables, Canadian notice, Avis canadian, Copyright

Advertising
background image

11

Insignia NS-LCD15F 15” LCD TV

www.insignia-products.com

Appendix

To attach a wall mount bracket to your TV:
1
Remove the four M4 screws holding your TV

to the stand.

2 Secure the wall mount bracket to the back of

your TV using the four M4 screws, as
indicated in the illustration.

Specifications

Design and specifications are subject to
change without notice.

Legal notices

FCC Part 15

This equipment has been tested and found to comply
with the limit for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does not cause harmful interference
to radio or television reception which can be
determined by turning the equipment off and on, the
user is encourage to try to correct the interference by
one or more of the following measures.

Reorient or relocate the receiving antenna.

Increase the separation between the
equipment and receiver.

Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.

Consult the dealer or an experienced radio or
TV technician for help.

Only a shielded interface cable should be
used.

Modifications

The FCC requires the user to be notified that any
changes or modifications made to this device that are
not expressly approved by Insignia may void the user’s
authority to operate the equipment.

Cables

Connections to this device must be made with shielded
cables with metallic RF/EMI connector hoods to
maintain compliance with FCC Rules and Regulations.

Canadian notice

This Class B digital apparatus meets all requirements
of the Canadian Interference-Causing Equipment
Regulations.

Avis Canadian

Cat apparel numerous de la classed B respected
toutes les exigencies du règlement sur le materiel
brouilleur du Canada.

Copyright

© 2007 Insignia. Insignia and the Insignia logo are
trademarks of Best Buy Enterprise Services, Inc. Other
brands and product names are trademarks or
registered trademarks of their respective holders.
Specifications and features are subject to change
without notice or obligation.

Analog standard

NTSC, PAL M, PAL N

Channel coverage

Air: 2-69
Cable: 1-125

Power source

DC 12 V

Power
consumption

<60 W
<1 W in standby mode

Audio power

2 W + 2 W internal speaker

S-Video input

Y:1 V(p-p), 75 ohm, negative sync
C:0.286 V(p-p) (burst signal), 75 ohm

Video/audio input

Video:1 V(p-p), 75 ohm, negative sync
Audio:150 mV(rms)

Component input

Y:1 V(p-p), 75 ohm, including sync
Pr/Cr:±0.35 V(p-p), 75 ohm
Pb/Cb:±0.35 V(p-p), 75 ohm
Suggested resolutions:1080i, 720p,
480p, 480i

VGA input

D-Sub 15-pin terminal
E-EDID compliant
Suggested scan rates:640×480 /60 Hz,
800×600 /60 Hz, 1024×768 /60 Hz
Audio input: Headphone mini-jack for
stereo

Remove stand

Remove M4 screws

Remove M4 screws

M4 screws

75 mm

75 mm

Attach wall
bracket here

Accessories

Power cord
Signal cable
Audio cable
AC adapter
User guide
Remote control
Batteries (2 AAA)

Advertising