Maytag W10239302B - Manuel (Page 5)

WARNING: To reduce the ris tric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS
before operating this appliance. The following is a guide to using your dryer.
Please refer to s sections of this manual for more detailed information.
NOTE: This Use and Care Guide covers several different models. Your dryer may not have all of the cycles and features described.
PAUSING OR RESTARTING
To pause the dryer at any time - Open the door or press
START • PAUSE once.
To restart the dryer - Close the door and press and hold
START • PAUSE button until dryer starts.
STOPPING YOUR DRYER
To stop the dryer at any time- Press POWER • CANCEL
once or open the door.
SIGNALS
CYCLE SIGNAL - Select ON or OFF, to alert you when a
cycle ends.
DAMP DRY SIGNAL - Select ON or OFF, to alert you when
your clothes are 80% dry.
Use a time cycle to set a drying time and
temperature.
1. Press POWER • CANCEL.
2. Rotate the dial to select a Timed Cycle.
3. Press the TIME ADJUST up or down buttons until the desired
drying time is displayed.
4. Press TIMED CYCLES TEMP until the desired temperature
glows.
Select the WRINKLE PREVENT feature, if desired.
5. Press and Hold START • PAUSE.
TIMED DRY - Select this cycle to control time and
temperature.
AIR DRY - Use Air Dry with TIMED DRY for items requiring
drying without heat.
TOUCH UP - Select this cycle to help remove wrinkles from
clean, dry clothes.
QUICK DRY - Select this cycle to dry small or loads
requiring less drying time.
USING TIMED CYCLES
STEAM CYCLES
Steam Cycles use water and heat to reduce
wrinkles and odors in dry items.
See “Cycles” for more details.
1. Press POWER • CANCEL.
2. Select a Steam Cycle.
3. Press and Hold START • PAUSE.
USING SENSOR CYCLES
Sensor Cycles automatically match the cycle
setting to the type of load, and adjust drying
time for optimal performance. See “Cycle
Setting Chart.”
1. Press POWER • CANCEL.
2. Select a Sensor Cycle.
3. Select WRINKLE PREVENT feature, if desired.
4. Press and Hold START • PAUSE.
To make changes during a Sensor Cycle:
1. Press START • PAUSE.
2. Select SENSOR CYCLES DRYNESS or Option.
3. Press and Hold START • PAUSE.
NOTE: For the Sanitize Cycle (on some models), do not
interrupt the cycle to ensure sanitization.
1. Clean lint screen before each load.
2. Place laundry in dryer and shut door.
3. Press POWER • CANCEL.
4. Select a cycle.
5. Press and Hold START • PAUSE to start.
START
QUICK START GUIDE
5