GE JGP963 - Manuel (Page 13)

13
Installation Instructions
MAKING THE LP CONVERSION
SAFETY INFORMATION YOU
SHOULD KNOW
The pressure regulator and burner orifices
are set for natural gas. To use LP gas,
the regulator and burner orifices must
be converted. The LP orifice spuds for
the cooktop burners can be located in the
literature package attached to the regulator.
CAUTION:
The cooktop, as shipped
from the factory, is set for use with natural
gas. If you wish to use your cooktop with LP
gas, you must first replace the orifices and
convert the pressure regulator.
WARNING:
This conversion must
be performed by a qualified installer or gas
supplier in accordance with the manufacturer’s
instructions and all codes and requirements
of the authority having jurisdiction. Failure
to follow instructions could result in serious
injury or property damage. The qualified
agency performing this work assumes
responsibility for the conversion.
CAUTION:
The following
adjustments must be made before turning
on the burner. Failure to do so could result in
serious injury. Be sure pressure regulator has
been converted as described in Step 2.
1
ADJUST YOUR COOKTOP FOR
USE WITH LP GAS
Disconnect all electrical power, at the
main circuit breaker or fuse box.
Shut off the gas supply to the cooktop
by closing the manual shut-off valve.
Adjust the pressure regulator, by the
following instructions:
• Unscrew the cap.
• Place your thumb against the flat side
of the spring retainer and press down
to remove the retainer.
• Carefully look at the spring retainer to
locate the NAT or LP position.
• Turn the spring retainer over so that
LP is showing on the bottom.
• Snap the retainer back into position.
• Screw the cap back onto the regulator.
C
B
A
2
DOWN FOR OFF
NAT
LP
LP
NAT
LP
NAT
NAT
LP
Gasket Cap
Spring
Retainer
L.P./Propane
Position
NAT.
Position
Pressure Regulator
TOOLS YOU WILL NEED
FOR LP CONVERSION
Safety Glasses
Small Flat-Head
Screwdriver (4mm
or 5/32
″
tip size,
60mm long)
Phillips- Head
Screwdriver
Pliers
7mm Nutdriver
No. 15 Torx-Head
Driver
If sold outside the U.S. and Canada:
WARNING:
If you wish to use this
product with Liquefied Petroleum (LP) gas
containing greater than 10% butane, you must
purchase a butane conversion kit. To order,
please call 1.888.664.8403 or 1.787.276.4051.
Model Butane Kit #
JGP970 WB28T10229
ZGU36 WB28T10229
JGP975 WB28T10231
JGP963 WB28T10233
JGP630 WB28T10235
JGP628 WB28T10236