Faber ISOLA - Manuel (Page 5)

4. Determine and make all necessary cuts for the ductwork.
Install damper when connecting ductwork. Install ductwork
before mounting the support. The damper attaches to the
inside bottom of the chimney support structure. It is necessary
to attach your ductwork to this damper and run the ductwork
inside the chimney support structure.
5. Determine the proper location for the Power Supply
Cable as indicated on the template. Use a 1 1/4" Drill Bit to
make this hole. Run the Power Supply Cable. Use caulking
to seal around the hole. DO NOT turn on the power until
installation is complete! Two knockouts are provided near
the exhaust exit on the canopy. One is for the Power Supply
Cable and one for an optional remote blower. Make sure that
you use the correct knockout.
6. Attach the support to the ceiling. Make sure that the
support is firmly connected to the ceiling. The height of the
canopy can be adjusted by changing the length of the support.
Adjust the support length by loosening the four set screws
(V) indicted in FIGURE 6. The bottom of the canopy will be
approximately 10 1/4 inches below the bottom of the support.
Make sure that all four set screws are firmly tightened before
attaching the canopy. To prevent damage, the support must
be adjusted BEFORE attaching the canopy.
ATTACH THE SUPPORT
1. Put a thick, protective covering over cooktop, set-in
range or countertop to protect from damage or dirt.
2. Determine and clearly mark with a pencil the center on
the ceiling where the rangehood will be installed.
3. A template for mounting the support is supplied in the
carton with the support. Use this template to mark holes for
support on the ceiling. The chimney must be disassembled
as indicated in FIGURE 5 to reveal the support. Before
disassembling the chimney, remove all screws ( 3 ).
FIGURE 5
FIGURE 6
INSTALL THE RANGEHOOD
1. Remove the unit from the carton and place on a flat
surface for assembly. Cover the surface to prevent accidental
damage. Remove all parts including the mounting hardware
before discarding the carton.
2. Remove the grease filters and set aside. The grease
filters are removed by pressing the handle in front of the
filter as indicated in FIGURE 7. When replacing, make sure
the filters are properly positioned with the handles visible in
front.
FIGURE 7
3. Remove the cover from the field wiring compartment.
Remove the wiring electrical knockout using a flat-blade
screwdriver.
4. The canopy attaches to the support by four bolts located
next to the duct exhaust opening. Loosen the four bolts so
that there is approximately 1/4" space between the bolt head
and the canopy. FIGURE 8 shows how the canopy attaches
to the support.
FIGURE 8
5. Lift the canopy and insert the bolts into the slots on
the support. Tighten the four bolts. Due to the weight of the
rangehood, two people should lift it to avoid injuries. Make
sure that the bolts are properly seated in the slots and fully
tightened.
6. Connect the Power Supply Cable to the rangehood.
Attach the White lead of the power supply to the White lead
of the rangehood with a twist-on type wire connector. Attach
the Black lead of the power supply to the Black lead of the
rangehood with a twist-on type wire connector. Connect the
Green ( Green and Yellow ) ground wire under the Green
grounding screw.
If your installation uses an optional remote blower, connect
the wiring cable for the blower. DO NOT CONNECT THE
REMOTE BLOWER DIRECTLY TO THE POWER SUPPLY
CABLE IN THE FIELD WIRING COMPARTMENT.
7. Replace the wiring compartment cover and grease
filters.
Version 11/00 - Page 5