Faber PELLICANO - Manuel (Page 7)

Version 10/05 - Page 7
Rangehood Control Panel
The control panel is located on the front edge of the rangehood.
The position and function of each control button are indicated
in FIGURE 9.
Light On/Off Button ( L )
On/Off switch for the halogen lights. Push the button in to
turn the light ON, push again to turn the light OFF.
Blower Indicator Light ( I )
Lights up to indicate blower is ON.
Blower On/Off and Speed Buttons ( 1, 2, 3 )
Push button (1) to turn ON and OFF the blower. This button
must be pushed in for the blower to operate regardless of
speed chosen. Button (1) operates the blower on LOW
speed. Push button (2) for MEDIUM speed. Push button
(3) for HIGH speed.
Cleaning
The stainless steel grease filters should be cleaned frequently
in hot detergent solution or washed in the dishwasher. Clean
exterior surfaces with a commercially available stainless
steel cleaner. Abrasives and scouring agents can scratch
stainless steel finishes and should not be used to clean
finished surfaces.
Replacing the Halogen Lamps
Before you begin, make sure that the rangehood is turned
off and that the other lamps have had sufficient time to cool.
Halogen bulbs burn extremely hot and serious injury could
result from touching a hot bulb. To replace the lamp, pull
from it's socket and reinsert new bulb.
• This rangehood uses 20 watt halogen lamps.
WARRANTY & SERVICE
All Faber products are warranteed against any defect in materials
or workmanship for the original purchaser for a period of 1 year
from the date of original purchase. This warranty covers labor
and replacement parts. The warranty does not cover consumable
parts such as filters and light bulbs. This warranty does not apply
if this product has been subjected to faulty installation, misuse, or
neglect. This warranty excludes any consequential expense or
damage resulting from any use or malfunction of the product. All
implied warranties are limited to the duration of this warranty.
To obtain warranty service, contact the dealer from whom you
purchased the rangehood, or the local Faber distributor. If you
cannot identify a local Faber distributor, contact us at (508) 358-
5353 for the name of a distributor in your area.
WIRING DIAGRAM
FIGURE 9
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from the
kitchen.
FUSE REPLACEMENT (IF NEEDED)
FUSE: Model 5 X 20 5A time delay
1. Remove the filters
2. Remove the screws fixing the fuseholder box.
3. Open the fuseholder (bayonet fixing)
4. Replace the fuse with another of the same type
5. Replace the fuseholder box and the filters