Faber Matrix - Manuel (Page 8)

Version 09/05 - Page 8
USE AND CARE CONTINUED - CONTROL PANEL
The hood can be operated from the control panel located on the right hand side of the hood or from
the remote control. The FIGURE 11 is an illustration of the control panel. The hood can be turned
on by pushing any speed button T1 thru T4 directly.
FIGURE 11
Turns lighting on and off.
First speed (press button)
When pressed for about 1 second, the motor is
switched off.
24 hour function (can operate all day and night to refresh
and clean your home)
This is enabled by pressing the button for approximately 5
seconds. It operates at 60 cfm with a noise level of just .5
sones. This function can be enabled at any speed, even with
the hood turned off. To disable, press and hold the button for
approximately 5 seconds.
Second speed (press button)
FUNCTIONS GREEN LED KEY
L 0 / 1 Light
T1 0 / 1 Motor
T2 Speed
T3 Speed
T4 Speed
S1 Red Led
ON
FLASHING
ON
FLASHING
ON
ON
FLASHING
ON
FLASHING
30 minute Delay Function
Press the button for 2 seconds to enable a 30 minute delay mode with automatic
shut off. This function is used to eliminate any residual odors for 30 minutes. This
can be enabled at any speed, even with the hood turned off and is disabled by
pressing the Speed 1 (On/Off) button for one second.
Third speed (press button)
Max. speed (press button)
Intensive Boost Function
Use this function to eliminate the strongest cooking vapors and odors. Press the
button for 2 seconds to enable the Intensive boost. After 10 minutes of intensive
power, the motor turns off automatically. This function can be enabled from any
speed even with the hood turned off, and is disabled by pressing any
speed buttton.
Indicates that the Metal grease filter saturation alarm has
been triggered, and the filters need to be washed. The alarm
is triggered after 100 working hours. (To Reset; see the
Maintenance paragraph)
Indicates that the charcoal filter saturation
alarm has been triggered, and the filter has to be replaced;
the metal grease filters must also be washed. The
charcoal filter alarm is triggered after 200 working hours when using a ductless
installation. (For Activation and to Reset; see the Maintenance paragraph)