Bissell PowerSteamer 1692 series - Manuel (Page 7)

To Fill The Tank-in-Tank (Continued)
Using the Measuring Cup, pour BISSELL Deep Cleaning
" Formula into the mouth of the bladder.
flk Fill to the bottom of the neck with hot tap water. Do not
^ boil or microwave water.
NOTE; Fill slowly to reduce sudsing.
I Replace the Tank Lid, matching the Lid and Tank edges.
Rotate the handle to carrying position. Replace Tank
in machine base, seating firmly in place. Rotate
handle back down to latched position.
When It’s Time To Empty The Tank-in-Tank
NOTE; Remove the Tank-in-Tank, following
steps 1 through 3 on page 6.
Pour out dirty water.
fik After each use, remove and rinse the Lint Screen located
” on the Tank Lid.
Remove Tank Lid, follow step 3 on page 6.
Remove Lint Screen. Rinse under faucet to
remove any debris.
(dInsert Lint Screen back in Tank Lid. The
screen will click into place.
Replace Tank Lid.
|3fc Refill with cleaning solution and clean tap water, follow
steps 4-5 above.
NOTE; When a cleaning job is complete, rinse out the
Tank-in-Tank by running clean water between the
bladder and the tank.
Return the Tank-in-Tank to the machine, follow
^ step 6 above.
flk Refer to the Maintenance/Storage section on the
^ next page for final cleanup.
Lint Screen
Lint Screen
A speciai red fioat device in the tank
wiii cause the cieaner to stop remov­
ing soiution from the carpet. The motor
sound wiii rise in pitch to iet you know
the dirty water tank is fuii.
08/09/05 19:04:23