Wash cycle information, Table 2 - wash cycle information, Interrupt a cycle – Bosch SHX4AT55UC Manuel d'utilisation

Page 18: Cycle completion signal, Delay start, Intensive drying, Infolight

Advertising
background image

16

Interrupt a cycle

1

Open the door, press the [On/Off] button to turn the unit off.

2 To resume the cycle, press the [On/Off] button again and close the door.

Cycle Completion Signal

1

Open the door and press the [On/Off] button.

2 Hold down the “A” button (see page 15) and press [Start] until the

display indicates “d:00”. Release both buttons.

3 Press the “A” button until the display shows “b:02”.
4 Press the “C” button to increase or decrease the tone “b:00” = OFF

and “b:03” = LOUDEST

5 Press [Start] to save setting and close the door.

Delay Start

You can delay the start of the cycle in one hour increments up to 24 hours.
1

Open the door and press the [On/Off] button and select desired cycle.

2 Press the [Delay] button until the displayed time corresponds with

your requirements.

h:01 = 1 hour delay h:24 = 24 hour delay

3 Press [Start] to activate delay start. Wash cycle will begin after set time.
To cancel delay start:
1

Press the [Delay] button until “h:00” is indicated on the digital display.

2 Press [Start] to save setting and close the door.

Intensive Drying

The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1

Open the door and press the [On/Off] button.

2 Hold down the “A” button (see page 15) and press [Start] until the

display indicates “d:00”. Release both buttons.

3 Press the “C” button to turn intensive drying on or off. “d:01” = ON

and “d:00” = OFF

4 Press [Start] to save setting and close the door.

InfoLight®

An LED illuminates the floor to indicate the unit is running. If the appli-
ance is installed at eye-level, the LED is not visible.
To change the setting:
1

Open the door and press the [On/Off] button.

2 Hold down the “A” button and press [Start] until the display indi-

cates “d:00”. Release both buttons.

3 Press the “A” button until the display shows “1:01”.
4 Press the “C” button to switch between “1:01” = ON and “1:00” =

OFF and press [Start] to save. Close the door.

Advertising