Sony SS-V521 Manuel d'utilisation

Satellite Sony

Advertising
background image

E

e

SURROUND BACK

Ee

English

Hooking up the speaker (A)

Connect the speaker to the speaker output terminals of
an amplifier.
Make sure power to all components (included the
subwoofer) is turned off before starting the hook-up.

Notes (B)

• Make sure the plus (+) and the minus (–) terminals on

the speakers are matched to the corresponding plus (+)
and minus (–) terminals on the amplifier.

• Be sure to tighten the screws of the speaker terminals

securely as loose screws may become a source of noise.

• Make sure all connections are firm. Contact between

bare speaker wires at the speaker terminals may cause
a short-circuit.

• For details regarding the connections on the amplifier

side, refer to the manual that was provided with your
amplifier.

Tip

All striped wires are minus (–) in polarity, and should be
connected to the minus (–) speaker terminals.

A

E

e

E

e

E

e

E

e

B

Micro Satellite Speaker

SS-V811ED/V521

Surround back

Foot pads

D

1

3

4

2

C

2001 Sony Corporation

Printed in China

Specifications

SS-V811ED (SS-MS815)

Speaker system

2 way, magnetically
shielded

Speaker units

Tweeter: 1.9 cm (

3

/

4

in.),

dome type
Woofer: 5 cm (2 in.)

×

2,

balanced drive type

Enclosure type

Bass reflex

Rated impedance

8 ohms

Power handling capacity
Maximum input power:

140 W

Sensitivity level

87 dB (1 W, 1 m)

Frequency range

120 Hz - 70,000 Hz

Dimensions (w/h/d)
When attached speaker grille:

Approx. 86

Ч

169

Ч

130

mm
(3

1

/

2

Ч

6

3

/

4

Ч

5

1

/

8

in.)

When attached to supplied speaker stand:

Approx. 96

Ч

207

Ч

141

mm
(3

7

/

8

Ч

8

1

/

4

Ч

5

5

/

8

in.)

Mass
When attached speaker grille:

Approx. 1.3 kg
(2 lb 14 oz)

When attached to supplied speaker stand:

Approx. 1.4 kg
(3 lb 1 oz)

SS-V521 (SS-MS525)

Speaker system

Full range

×

2,

magnetically shielded

Speaker units

5 cm (2 in.), balance

drive

type

Enclosure type

Bass reflex

Rated impedance

8 ohms

Power handling capacity
Maximum input power:

120 watts

Sensitivity level

87 dB (1 W, 1 m)

Frequency range

120 Hz - 20,000 Hz

Dimensions (w/h/d)

Approx. 89

Ч

144

Ч

130 mm
(3

5

/

8

Ч

5

3

/

4

Ч

5

1

/

8

in.),

including front grille

Mass

Approx. 750 g
(1 lb 10 oz)

Positioning the speakers

Location of each speaker

Tips

• Movies are best enjoyed in a room that produces no

echoes (as in one with surrounding curtains).

• Music (especially classical music) is best enjoyed in a

room that produces some echo.

Positioning the speaker
(for SS-V811ED only) (

C

)

Attach the speaker to supplied speaker stand and place
them at their optimum locations.
For details on the location of the speaker, see “Location
of each speaker”.

1

Detach the plate from the stand.

2

Pass the speaker cord into the hole on the
back of the stand and out from the hole at the
center of the stand.

3

Separate the speaker cord, then secure the
cord to the speaker stand with the plate.

4

Connect the speaker cord to the speaker
terminal.
The cord should be pressed into the groove
in the stand.

5

Using the supplied screws and washers,
secure the speaker to the stand.

Note

Do not remove the supplied speaker grille from the
speaker while attaching the speaker to the speaker stand.

Setting the speaker
(for SS-V521 only) (

D

)

To prevent speaker vibration or movement while
listening, attach the supplied foot pads to the speaker.

Precautions

On operation

• Do not drive the speaker system with a continuous

wattage exceeding the maximum input power of the
system.

• If the polarity of the speaker connections are not

correct, the bass tones will be weak and the position of
the various instruments obscure.

• Contact between bare speaker wires at the speaker

terminals may result in a short-circuit.

• Before connecting, turn off the amplifier to avoid

damaging the speaker system.

If you encounter color irregularity on a
nearby TV screen

This speaker system is magnetically shielded to allow it
to be installed near a TV set. However, color
irregularities may still be observed on certain types of TV
sets.

If color irregularity is observed...

c

Turn off the TV set once, then turn it on again after
15 to 30 minutes.

If color irregularity is observed again...

c

Place the speakers further away from the TV set.

If howling occurs

Reposition the speakers or turn down the volume on the
amplifier.

On placement

• Do not set the speakers in an inclined position.
• Do not place the speakers in locations that are:

Extremely hot or cold

Dusty or dirty

Very humid

Subject to vibrations

Subject to direct sunlight

On cleaning

Clean the speaker cabinets with a soft cloth lightly
moistened with a mild detergent solution or water. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.

If you have any questions or problems concerning your
speaker system, please consult your nearest Sony dealer.

Amplifier

4-233-678-11(1)

Front (Right)

Subwoofer

Rear(Right)

Front (Left)

Rear (Left)

Center

Surround back

5

Features

The instructions in this manual are for SS-V811ED and
SS-V521, Sony Micro Satellite Speaker.
If you add this speaker to SA-VE815ED and SA-VE525,
you can enjoy the surround effect as a 6.1 channel
speaker system. Please refer to the manual provided for
SA-VE815ED and SA-VE525 when you connect this
speaker to the other speakers of SA-VE815ED and SA-
VE525.

Any difference in operation is clearly indicated in the
text, for example, “SS-V811ED only”.

Supplied accessories

Speaker stand (1) (SS-V811ED only)
Screws (2) (SS-V811ED only)
Washers (2) (SS-V811ED only)
Plate (1) (SS-V811ED only)
Foot pads (4) (SS-V521 only)
Speaker connecting cords, 10 m (32 ft 9

3

/

4

in.) (1)

Design and specifications are subject to change without
notice.

Advertising
Ce manuel est liée aux produits suivants: