GE Profile SmartWater ULTRA PLUS FQROPF Manuel d'utilisation

Ge profile, Smartwater, Ultra plus

Advertising
background image

GE Profile

SmartWater

ULTRA PLUS

GE Model FQROPF Replacement Filter / Filtre de remplacement, modèle de GE FQROPF /

Filtro de recambio, modelo de GE FQROPF

Do not use with water that is microbilogically unsafe or of unknown quality
without adequate disinfection before or after the system.
Small parts remaining after the installation could be a choke hazard. Discard
safely.

Your new GE reverse osmosis replacement filter gives you up to 6 months of great-tasting water. Filter should be changed after 6 months of use.
Votre nouveau filtre de remplacement osmose inversée GE procure une eau d’excellente qualité équivalant à environ 6 mois d’utilisation. On devrait changer le filtre après 6 mois d’utilisation.
Su nuevo filtro de reemplazo osmosis inversa GE le ofrece hasta 6 meses de agua de excelente sabor. El filtro deberá cambiarse después de 6 meses de uso.

WARNING

This System has been tested according to NSF/ANSI 42 for the reduction

of the substances listed below. The concentration of the indicated
substances in water entering the system was reduced to a concentration less
than or equal to the permissible limit for water leaving the system, as
specified in NSF/ANSI 42.

Actual performance may vary with local water conditions.

Do not use with water that is microbiologically unsafe or with water of

unknown quality without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used on disinfected waters that
may contain filterable cysts.

Ce système a été testé conformément aux normes NSF/ANSI 42 pour

assurer la réduction des substances listées ci-dessous. La concentration des
substances spécifiées dans l’eau arrivant au système a été réduite à une
valeur inférieure ou égale à la limite admise pour l’eau sortant du système
tel que défini dans les normes NSF/ANSI 42.

Les performances réelles peuvent varier selon les conditions de l’eau

fournie localement.

Ne pas utiliser ce produit sans une désinfection adéquate avant ou après le

système, avec d’eau de qualité inconnue ou microbiologiquement polluée. Les
systèmes homologués pour la retenue des spores peuvent être utilisés pour
la filtration d’une eau désinfectée qui peut contenir des spores filtrables.

Este sistema ha sido probado de acuerdo con NSF/ANSI 42 para la

reducción de las sustancias mencionadas más adelante. La concentración
de las sustancias indicadas contenidas en el agua que entra al sistema fue
reducida a una concentración menor o igual al límite permitido para el
agua que sale del sistema, según las normas establecidas por NSF/ANSI 42.

El desarrollo real podría variar de acuerdo con las condiciones locales del

agua.

No debe usarse en aquellos lugares en los que el agua no es

microbiológicamente segura, o si se desconoce la calidad del agua.
Cerciórese de que el agua se desinfecta adecuadamente, ya sea a la entrada
o a la salida del sistema. Sistemas certificados para reducción de quistes
pueden ser usados en agua desinfectada que podrían contener quistes
filtrables.

Tested and certified by NSF International against NSF/ANSI Standard 42
in models PNRQ15F, PNRQ15FBL and PNRQ20F for the reduction of the
claims specified on the Performance Data Sheet.

AVERTISSEMENT

Testé et homologué par NSF International selon les normes
No. 42 NSF/ANSI dans les modèles PNRQ15F, PNRQ15FBL, et PNRQ20F
pour la réduction des prétentions indiquées dans la feuille des données de
performance.

No usar con agua que sea microbiológicamente insegura o de calidad
desconocida sin desinfectarla como es debido antes o después del sistema.
Cerciórese de que el agua se desinfecta adecuadamente, ya sea a la entrada o
a la salida del filtro.
Las pequeñas piezas que sobran después de la instalación pueden constituir
un riesgo de asfixia. Deséchelas adecuadamente.

ADVERTENCIA

Probado y certificado por NSF International contra los Estándares
NSF/ANSI 42 en los modelos PNRQ15F, PNRQ15FBL y PNRQ20F para la
reducción de los reclamos especificados en la Hoja de Datos de Desarrollo.

Replacement Filter Cartridges/Estimated Replacement Costs

FQROPF—Replacement filter cartridge $35–$40
For replacement parts, call toll free 800.626.2002 (U.S.),
800.663.6060 (Canada-English), 800.361.3869 (Canada-French).

Cartouches filtrantes de remplacement/Coûts de remplacement
estimés

FQROPF—Cartouche à filtre de remplacement 35 $–40 $
Pour des pièces de remplacement, composer le numéro sans frais
800.626.2002 (É.-U.),
800.663.6060 (Canada-Anglais), 800.361.3869 (Canada-Française).

Cartuchos de filtro de reemplazo/costos estimados de reposición

FQROPF—Reposición del recipiente del filtro $35–$40
Para partes de reemplazo, llame gratis al 800.626.2002 (EE.UU.),
800.663.6060 (Canadá-inglés), 800.361.3869 (Canadá-francés).

Ne pas utiliser ce produit sans une désinfection adéquate avant ou après le
système, avec d’eau de qualité inconnue ou microbiologiquement polluée.
Les petites pièces non utilisées après l’installation peuvent susciter
un risque d’étouffement pour les jeunes enfants. Veiller à les éliminer.

SPECIFICATIONS / SPÉCIFICATIONS / ESPECIFICACIONES

ELEMENTO DE

REEMPLAZO

ELEMENT DE

REMPLACEMENT

REPLACEMENT

ELEMENT

State of California

Department of Health Services

Water Treatment Device

Certificate Number

Date Issued: January 6, 2005

Trademark/Model Designation

Replacement Elements

1677

05 -

GE Smartwater PXRQ15F

FQROPF (Pre and Post Filter)
FQROMF (Membrane)

GE Smartwater PNRQ15FBL

FQROPF (Pre and Post Filter)
FQROMF (Membrane)

Manufacturer: General Electric Company

The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section
116830 of the Health and Safety Code for the following health related contaminants:

Cysts

Turbidity

Arsenic

1

Asbestos
Barium
Cadmium
Chromium (hexavalent)

Chromium (trivalent)
Copper
Lead
Selenium

None

Microbiological Contaminants and Turbidity

Inorganic/Radiological Contaminants

Organic Contaminants

Do not use where water is microbiologically unsafe or with water of unknown quality, except that systems certified for
cyst reduction may be used on disinfected waters that may contain filterable cysts.

1

Claims for arsenic reduction shall only be made on water supplies maintaining detectable residual free chlorine at the

reverse osmosis (RO) system inlet. Water systems using an in-line chlorinator should provide a minimum of 1 minute
chlorine contact time before the RO system.

900 gal

Rated Service Capacity:

11.15 gpd

Rated Service Flow:

Conditions of Certification:

USEPA

Influent

Influent

Effluent

% Reduction

Min. Required

Parameter

MCL

Challenge Concentration

Average

Average

Maximum

Average

Minimum

Reduction

USEPA

Concentation d’amorce

Moyenne dans

Eau sortante

Réduction en pourcentage

Réduction requise

Parametre

MCL

dans l’eau entrante

l’eau entrante

Moyenne

Maximum

Moyen

Minimum

minimum

USEPA

Influente Influente

Efluente

% de reducción

Reducción mínima

Parámetro

MCL

Concentración de reto

Promedio

Promedio

Máximo

Promedio

Mínimo

necesaria

Standard No. 42: Aesthetic Effects / Norme No. 42: Effets esthetics / Estándar No. 42: Efectos aestéticos

Chlorine/

2.0 mg/L ± 10%

1.89 mg/L

<0.0568 mg/L

0.10 mg/L

>96.98%

94.74%

≥50%

Chlore/Cloro

T & O

Particulate**/

at least 10,000 particles/mL/

3,800,000 #/mL

26,834 #/mL

80,000 #/mL

99.37%

98.26%

≥85%

Particules/Partículas

Au moins 10 000 particules/ml/

por lo menos 10,000 partículas/mL

**Measurement in particles/mL. Particles used were 0.5–1 microns
Operating Specifications
Capacity: certified for up to 900 gallons (3,411 l); up to six months
Pressure requirement: 40–120 psi (2.8–8.2 bar)
Temperature: 33–100°F (0.6–38°C)
Flow rate: 1.15 gpm (4.36 lpm)

**Mesure en particules/ml. Particules utilisés de 0,5-1 micron

Caractéristiques techniques de fonctionnement
Capacité certifiée pour jusqu’à 3 411 l (900 gallons); jusqu’à six mois
Exigences de pression : 40-120 psi (2,8-8,2 bar)
Température : 0,6-38°C (33-100°F)
Taux de circulation : 4,36 lpm (1,15 gpm)

**Medidas en partículas/mL. Partículas usadas eran de 0.5-1 micrones

Especificaciones operativas
Capacidad: Certificado para un máximo de 3,411 litros (900 galones); hasta
seis meses.
Requisitos de temperatura: 40-120 psi (2.8 – 8.2 bar)
Temperatura: 0.6º - 38º C (33º - 100º F)
Ritmo de flujo: 4.36 lpm (1.15 gpm)

GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225

www.GEAppliances.com

101204 215C1177P001

(05-05 JR) 49-50146-2

State of California

Department of Health Services

Water Treatment Device

Certificate Number

1706

Date Issued: April 18, 2005

Trademark/Model Designation

05 -

GE Profile PNRQ20FBL

GE Profile PNRQ20FBB

GE Profile PNRQ20FCC

GE Profile PNRQ20FWW

Manufacturer:

General Electric Company

The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section
116830 of the Health and Safety Code for the following health related contaminants:

Cysts
Turbidity

Arsenic

1

Asbestos
Barium
Cadmium
Chromium (hexavalent)
Chromium (trivalent)
Copper
Lead
Nitrate/Nitrite

2

Selenium

None

Microbiological Contaminants and Turbidity

Inorganic/Radiological Contaminants

Organic Contaminants

900 gal

Rated Service Capacity:

1.15 gpm

Rated Service Flow:

Do not use where water is microbiologically unsafe or with water of unknown quality, except that systems
certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

1

Claims for arsenic reduction shall only be made on water supplies maintaining detectable residual free chlorine at the

reverse osmosis (RO) system inlet. Water systems using an in-line chlorinator should provide a minimum of 1 minute
chlorine contact time before the RO system.

FQROPF Prefilter
FQROMF Membrane
FQROPF Postfilter

Replacement Elements:

2

This system is acceptable for treatment of influent concentrations of no more than 27 mg/L nitrate and 3 mg/L nitrite in

combination measured as N and is certified for nitrate/nitrite reduction only for water supplies with a pressure of 280
kPa (40 psig) or greater. A sampling and analysis test kit for nitrate is provided for checking the performance of this
system. Frequent analysis is encouraged.

Advertising