HP Photosmart C4500 - Manuel (Page 11)

To connect the product
1. Insert the product software CD in the computer CD-ROM drive.
2. Follow the instructions on the screen.
When you are prompted, connect the product to the computer using the USB setup
cable included in the box. The product will attempt to connect to the network. If the
connection fails, follow the prompts to correct the problem, and then try again.
3. When the setup is finished, you will be prompted to disconnect the USB cable and
test the wireless network connection. Once the product connects successfully to the
network, install the software on each computer that will use the product over the
network.
Connect to additional computers on a network
You can connect the HP All-in-One to a small number of computers on a network. If the
HP All-in-One is already connected to a computer on a network, for each additional
computer you must install the HP All-in-One software. During installation of a wireless
connection, the software will discover the product on the network. Once you have set up
the HP All-in-One on the network you will not need to configure it again when you add
additional computers.
To install the Windows HP All-in-One software on additional networked computers
1. Quit all applications running on your computer, including any virus detection software.
2. Insert the Windows CD that came with the HP All-in-One into the CD-ROM drive on
your computer and follow the onscreen instructions.
3. If a dialog box about firewalls appears, follow the instructions. If you see firewall pop-
up messages, you must always accept or allow the pop-up messages.
4. On the Connection Type screen, select Through the network, and then click
Next.
The Searching screen appears as the Setup program searches for the HP All-in-One
on the network.
5. On the Printer Found screen, verify that the printer description is correct.
If more than one printer is found on the network, the Printers Found screen appears.
Select the HP All-in-One you want to connect.
6. Follow the prompts to install the software.
When you have finished installing the software, the HP All-in-One is ready for use.
7. If you disabled any virus detection software on your computer, make sure to enable
it again.
8. To test your network connection, go to your computer and print a test page to the
HP All-in-One.
Change the HP All-in-One from a USB connection to a
network connection
If you first install the HP All-in-One with a USB connection, you can later change to a
wireless network connection. If you already understand how to connect to a network, you
can use the general directions below.
Change the HP All-in-One from a USB connection to a network connection 7
Engl
is
h