Hitachi 46F500 - Manual (Page 30)

30
USING THE REMOTE TO CONTROL
DVD FUNCTIONS
Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of
your DVD player. (refer to page 31 for pre-codes)
1. Turn ON your DVD player.
2. Aim the remote control at the front of your DVD player.
3. Press and release the DVD/VCR button to switch to DVD pre-coded mode.
4. Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your DVD player, as shown on page
31.
5. Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two
digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not
turn off, try a different two digit preset code.
6. The remote will now control your DVD player.
NOTES:
1.
If your DVD player cannot be operated after performing
the above procedures, your DVD player’s code has not
been precoded into the remote.
2. In the unlikely event that your DVD player cannot be
operated after performing the above procedures, please
consult your DVD player operating guide.
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
ቢ
DVD/VCR Button
This button allows the remote to control your DVD player by
setting it to DVD mode.
ባ
PRECODED DVD Buttons
These buttons transmit the chosen precoded DVD codes.
ቤ
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
1 2 3
4 5 6
7 8 9
0 ANT INFO
VOL CH
POWER
TV CBL/SAT DVD/VCR
PIP
SWAP PIP MODE
FREEZE
VIDEO MENU
MUTE
EXIT
LAST CH
REC ASPECT VIRTUAL HD
SELECT
PIP CH
CLU-4321UG
VID1 VID2 VID3 VID4
VID5
ቢ
ቤ
ባ
MY DVD PLAYER CODE IS:
NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.