HP 8200 series - Manuel (Page 17)

user’s manual
how to use the scanner
11
En
gl
ish
run the cleaning cloth through the ADF
1
Open the sealed container, starting at the notch. Take care not to tear the
cleaning cloth inside.
2 Remove the cleaning cloth and unfold.
3 Place the unfolded cloth into the paper input tray.
4 Press the S
CAN
D
OCUMENT
T
O
button.
The cleaning cloth will run through the ADF.
Wait two minutes to allow the components to dry before proceeding to the
next step.
5 Place up to five pages of printed paper in the paper input tray. Scan and
view the results.
6 If streaks still appear, repeat Steps 3 through 6.
The cleaning cloth can be cycled through the ADF up to five times.
clean the feed roll assembly manually
1
Open the hatch and lift the green tab to the fully open position. The feed
roller assembly should be in a nearly vertical position.
2 With a Paper Path Cleaning Cloth (C9915-60056), clean each of the feed
rollers and the small rubber pad located below the rollers.
Note: If you do not have the paper path cleaning cloth, use a lint-fee cloth
slightly dampened with isopropyl alcohol.
3 Wipe the area around the small rubber pad to remove any paper dust.
4 Lower the green tab and feed roller assembly.
5 Close the hatch.
place the unfolded cloth into the paper input tray
scan up to five pages
lift the green tab to expose the feed rollers
scanner03_Usermanual.book Page 11 Friday, March 21, 2003 9:57 AM