Portable Winch Winch support plate w/bent pin PCA-1268 - Manuel

PCA-1268 – WINCH SUPPORT PLATE
Includes: 1 x winch support plate, 1 ‘’R’’ pins, 1 bent pin.
(PCA-1265, PCA-1266 et PCA-1267 sold separately)
Using the winch support plate (PCA-1268) with square tubing 50 mm (2'') (PCA-1267)
1) Figure 1, no. 1: Slide the square tubing (PCA-1267) into the vehicle’s receiver and secure it with both the hitch pin
and the ‘’R’’ pin;
2) Figure 1, no. 2: Slide the winch support plate (PCA-1268) onto the square tubing and secure it with both the hitch
pin and the ‘’R’’ pin;
Note: Its lateral movement can be adjusted by positioning the bolts into the square holes;
3) Figure 2: Attach the winch anchor hooks to the eye bolts;
4) Figure 2: Wrap the rope around the drum and start winching. The winch will align itself automatically with the load.
Using the winch support plate (PCA-1268) with Heck-Pack system for 50 mm European balls
(PCA-1266) and winch support plate adaptor (PCA-1265)
1) Figure 1: Bolt the winch support plate adaptor (PCA-1265) onto the Heck-Pack system (PCA-1266) with the 4
bolts provided;
2) Figure 2: Insert the Heck-Pack on the ball and fasten it down with the lever;
3) Figure 2: Slide the winch support plate (PCA-1268) onto the square tubing and secure it with both the hitch pin
and the ‘’R’’ pin;
Note: Its lateral movement can be adjusted by positioning the bolts into the square holes;
4) Attach the winch anchor hooks to the eye bolts (as shown in section 3.3.3);
5) Wrap the rope around the drum and start winching. The winch will align itself automatically with the load.
IF YOU NEED TO PULL DOWNWARD, YOU WILL NEED TO INSTALL EITHER A PULLEY OR A
ROLLER TO PREVENT DAMAGE TO THE WINCH SUPPORT PLATE.
MAKE SURE THE ANCHORING VEHICLE’S HAND BRAKE IS ON AND WORKING PROPERLY.
POSITION BLOCKS BEHIND THE WHEELS TO PREVENT ROLL BACK.
© Portable Winch Co. – All rights reserved