Add rinse aid, Select a cycle (cycles vary by model), Select options (options vary by model) – Whirlpool quiet partner iii Manuel d'utilisation

Page 4: Start or resume a cycle, Step 3 step 4

Advertising
background image

4

Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.

NOTE: Fill amounts shown
are for standard powdered
detergent. Follow
instructions on the package
when using other
dishwasher detergent.

Add Rinse Aid

Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid, your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.

Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.

Rinse aid helps to reduce excess moisture on the
dish racks and interior of your dishwasher.

Check the rinse aid indicator. Add rinse aid when indicator
drops to “Add” level.

To add rinse aid, turn the dispenser cap
to “Refill” and lift off. Pour rinse aid into
the opening until the indicator level is at
“Full.” Replace the dispenser cap and
turn to “Lock.” Make sure cap is fully
locked.

NOTE: For most water conditions, the
factory setting of 2 will give good
results. If you have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting a
flat-blade screwdriver into the center of
the arrow and turning.

Select a Cycle (cycles vary by model)

See “Cycle and Option Descriptions” charts in the following
section.

Heavier cycles and options affect cycle length. Some cycles and
options will take up to 3

¹⁄₂ hours to complete.

Select Options (options vary by model)

See “Cycle and Option Descriptions” charts in the following
section.

You can customize your cycles by pressing the options desired.

Start or Resume a Cycle

Run hot water at the sink nearest your dishwasher until
the water is hot. Turn off water.

Push door firmly closed. The door latches
automatically. Select the wash cycle and options
desired OR press START/RESUME to repeat the same
cycle and options as in the previous wash cycle.

You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.

Soft Water

Hard Water

Soft Water

Hard Water

Main Wash

Pre-Wash

Full

Add

¹⁄₄

turn to lock

Lock

Refill

6

5 4

3

2

- -

-

max

fill

1

- -

-

-

- - -

-

-

-

-

6

5

4

3

2

- -

-

max

fill

1

- -

-

-

- - - -

-

-

-

-

STEP 3

STEP 4

Advertising
Ce manuel est liée aux produits suivants: