Whirlpool 810 - Manuel (Page 5)

Water
requirements
All solder connections must be
made before the water line Is
connected to the dishwasher to
prevent damage to Inlet valve.
Do Not solder within 6 Inches
(15 cm) of the Inlet valve. The
plastic part of the Inlet valve could
be damaged.
The hot water line to the
dishwasher must provide between
15-120 psi (103-827 kPa) water
pressure.
The hot water heater should be set
to deliver 120“F (49°C) water
temperature to the dishwasher for
best results.
Use 3/8" (9.5 mm) O.D. copper
tubing or 1/2" piastic tubing
minimum inlet line. Dishwasher inlet
valve has 3/8" internal pipe thread.
Water line
connection
A
warning
>4
Electrical Shock Hazard
Disconnect electrical power at the
fuse box or circuit breaker box
before installing dishwasher.
Failure to follow this instruction
can result in death or electrical
shock. 1
I Disconnect the electrical
power supply. Put on gloves and
safety glasses.
cabinet
wall
6 "
(15.2 cm)
water supply
pipe
alternate
water-line
locations
(10.2 cm)
2-1/2".
(6.4 cm)
I Cut a 1 /2" (1.3 cm) minimum
hole in cabinet rear wall or floor for
water line.
Oa Rough in water line through
the 1/2" (1.3 cm) minimum hole to
dishwasher cabinet opening.
■•a Install a shutoff valve
in the water line where it
can be easily used.
wa Flush water line into a bucket
to get rid of any particles that may
clog the inlet valve. Turn the
shutoff valve to "OFF" position.
6
a
Check that there are no
sharp bends or kinks in the water
line that may restrict the water
flow.
Page 5