Whirlpool 810 - Manuel (Page 11)

Custom panel dimensions
Noto: This panel is narrower than
access panel.
File or sand edges of wood panel to
avoid slivers.
door panel
side view
top edge 7/32"
(0.56 cm)
Routing custom panels
3/8"
sn~(0.95 cm)
±
w
k.
T
7/32"
(0.56 cm)
bottom
edge
door panel
front view
1"
(2.5 cm)
access panel
side view
Cut door panel to
clear access panel
when door is in
open position.
door
closed
door
^--^pivot
access
panel
7/32"
top view (0-56 cm) thick
V access
panel frame
1/4"
(0.64 cm)
min.
Custom door panel more than
7/32" (0.56 cm) thick: Route top
and bottom to 7/32" (0.56 cm)
thickness.
Custom access panel more than
7/32" (0.56 cm) thick: Route all four
sides to 7/32“ (0.56 cm) thickness.
Custom panels less than 7/32"
(0.56 cm) thick: Install spacers
behind panels.
4-7/16"
(11.3 cm)
All edges routed to 7/32" (0.56 cm)
thickness.
Note: This panel is wider than the door
panel.
To install
customized
wood panels in
door and access
panel
1 ■ Cut wood door and access
panels using specified dimensions,
Make sure wood grain direction
matches cabinet wood grain.
^ ■ File or sand edges of wood
panels to avoid slivers.
Dishwasher Is subject to some
humidity. Cover both sides and
edges of wood panels with
moisture-resistant sealer.
A
warning
Injury Hazard
Wear gloves and handle panels
carefully.
Cut metal edges are sharp and
may cause serious injury.
W ■ Insert
finger under
one end of
refainer and
pull towards
you in a peeling
action. Set
retainer aside.
4
■ Lift door
panel(s) at outer
edges. Use one
hand to bow
bottom of
panel(s). Remove
panel(s) and
spacer. Save
panel(s) and
spacer for future use
Page 11