Setting the controls, Changing the bin door panel – Whirlpool 2180633 Manuel d'utilisation

Page 6

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

U S I N G Y O U R I C E M A K E R

Setting the controls

1. Select ice thickness. The ice maker has

been preset to produce ice approximately

Vz" (13 mm) thick, while operating in a
room temperature of 70°F (21 °C).

Operation in different room tempera­

tures may require readjusting the control
toward THICK" or THIN."

Best operation will be obtained with ice

Vz" (13 mm) to ®/a' (16 mm) thick.

If operating in a warm room (above

90°F [32'’C]) DO NOT set control to
maximum thickness or the unit may
malfunction.

2. To start the normal ice making cycle, turn

the Cycle Control Knob to “ON."

3. To stop ice maker operation, turn Cycle

Control Knob to “OFF."

The “CLEAN" setting is used whenever
solutions are circulated through the ice

maker for cleaning. Only the water pump

operates at this setting. See “Cleaning the

ice maker system" on page 11 for specific
instructions.

Changing the bin door panel

You can easily change the color of the front
panel on the storage bin door. Two colors
are available: Black and White.

To change panel:

1. Open the storage bin door. Remove the

two screws on the top of the door, which

hold the handle.

2. Loosen the screws in both of the side trim

pieces.

3. Remove the handle and the handle insert.

4. Carefully slide the panel out. You will find

the reverse side is white. For units with
white panels showing, the reverse side
will be black.

5. Choose the color you want to show and

carefully slide the panel back into the
door.

NOTE: Be careful not to scratch the panel

as it is inserted.

Advertising