Panasonic DVD-PV40 - Manuel (Page 10)

Preparing the remote control Power supply
^1 I I
■ Replacing the button-type battery
The battery normally lasts for about a
year. Replace if the remote control fails to
operate the unit when used within the
operation range.
I7ffn
Refer to “IMPORTANT SAFETY
INSTRUCTIONS” on pages 6 and 7,
This figure shows DVD-LV60.
Remote control
signal sensor
About 7 m~T
{23 feet) in
front of the
signal sensor
• Do not expose the remote control signal
sensor to bright light.
• Do not place obstacles between the
remote control signal sensor and the
remote control.
• Do not use another unit’s remote control
at the same time,
This figure shows DVO-LV60.
The [cb] indicator lights.
[ Front of
this unit
Refer to “IMPORTANT SAFETY
INSTRUCTIONS” on page 6.
The unit is in the standby condition {the
[Cb] indicator lights) when the AC adap­
tor is connected. The primary circuit is
always “live” as long as the AC adaptor
is connected to an electrical outlet.
■ When the unit is not going to be
used for a long time
The unit consumes 2 W when in standby
mode.
To conserve power, disconnect the AC
adaptor from the AC outlet.
RQT5931