Mounting the lens, Caution for mounting the lens, Cable – Panasonic WV-CP110 Manuel d'utilisation

Page 2: Connections, Focus or flange-back adjustment, Installing procedure

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

CONNECTIONS

aution:

Keep the POWER switch of the specified

monitor, Camera Extension Unit and Camera
Drive Unit in OFF position during connec*
tions. If the power of these units are ON dur­
ing connections, the camera does not func­

tion due to protect circuit from misconnec-
tion.

• Basic System

Connect the single coaxial cables between
the Camera and Camera Input Terminal of
Specified moriitor or Camera Drive Unit. The
approx, maximum cable length is as:

Coaxial

Cable
Type

Maximum

Cable

Length

DC R/1 000 ft.
of Inner

Conductor

RG-59/U

200 m (660 ft) Less than

son

RG-6/U 500 m {1 650 ft) Less than

12L2

The maximum DC resistance between the
camera and these units is 20 ii.

Connection Diagram

Camera

Mounting the Lens

Caution:

Before you mount the lens, loosen the two
screws on the ring, and rotate this ring clock­

wise until it stops. If the ring is not at the end,
the inner glass or CCD image sensor may be
damaged.

® Mount the lens by turning it clockwise on the

lens mount of the camera.

(D Connect the lens cable to the auto iris lens

connector on the side of the camera.

Caution for Mounting the Lens

The lens mount should be a C-mount or CS-mount
(T'-32UN) and the lens weight should be less than
450 g (0.99 lbs). If the lens is heavier, both the

lens and camera should be secured by using the

supporter.
The protrusion at the rear of the lens should be as
shown in the diagram.

CS-mount: Less than 8 mm (5/16”)

Caution:

To use the C-mount lens, the Lens

Mount Converter (C-mount adapter) WV-

AD20 should be used with the camera.

FOCUS OR FLANGE-BACK ADJUSTMENT

The following adjustment should be made by
qualified service personnel or system installers,

© Loosen the screws on the flange-back adjust­

ing ring.

Flange-back
Adjusting Ring

INSTALLING PROCEDURE

The mounting bracket can be fixed either on the
top or the bottom cover of the camera.
When mounting on the top cover of the camera,
detach the mount adapter from the bottom of the

j camera cover and attach it on the top cover of the
' camera.

(2) Turn the flange-back adjusting ring to the

desired position.

Caution:

Do not rotate the ring counterclock­

wise by force after it stops. If the ring is

rotated by force, the inner lens or CCD
image sensor may be damaged.

(5) Tighten the screws on the flange-back adjust­

ing ring.

3,

Fix the camera mounting bracket on the wall
or ceiling to be installed by two screws (to be
procured locally).
Insert the camera fixing screw on the par
head into the camera mounting adapter, anc
tighten the pan head firmly.
Connect the camera and the monitor with the
coaxial cable (to be procured locally).

Camera Drive Unit
WV-PSllB

Advertising