Panasonic AG-TL500 - Manuel (Page 7)

e 0 0
O
AC IN connector
Connect the supplied power cord to an AC outlet.
e Battery installation area
Install the battery in this area. See “Lithium Battery”
on page 2.
0 Audio input/output connectors
Audio input/output connectors (phono jacks)
O
Video input/output connectors
Video input/output connectors (BNC); connect the
input connector to the video camera, etc. and the
output connector to the TV monitor, etc.
0 RS-232C connector
This enables the basic functions of the VTR to be
operated using a personal computer, etc.
0 MIC input jack
Input jack (mini-jack) for an external microphone.
This jack has precedence when signals are
supplied simultaneously to this jack and the audio
input connectors.
O REMOTE control connector
For connecting the AG-Al 1 remote controller which
is available as an optional accessory.
0 Camera switching output connector
Camera switching output connector: connect it to
the frame switcher.
0 Alarm input connector
Alarm recording input connector; connect it to the
external sensor.
0 COMMON terminal
0 Alarm reset Input connector
Input connector for releasing alarm recording; a +4
to +14V DC voltage is required.
0 REC INPUT connector
When signals are input to this connector, the
following operations are performed depending on
the setting of SW6 in Fig. 1 (see page 21).
SW6 OFF: When signals are supplied to the REC
IN connector, the power is automatically
turned on, and recording is performed.
When the signals are no longer sup­
plied, the power Is automatically turned
off.
ON: When signals are supplied to the REC
IN connector, turning on the power
causes recording to be performed.
0 Tape end output connector
When the cassette tape comes to its end during
recording, the alarm deviceinstalled externally is
activated.
0 WARNING/REC output connector
When trouble has occurred in the unit, the alarm
device installed externally is activated.