Battery replacement (remote control unit), Remove the battery holder, Replace the battery – Panasonic CQ-VX777EUC Manuel d'utilisation
Page 57: Insert the battery holder, Note on batteries, Caution, Sound controller, Used with equalizer
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
□ Sound Controller
PROBLEM
POSSIBLE CAUSE
PROBABLE SOLUTION
No sound from front preamplifi
er output
Fader is set to the rear position.
Set the fader toward the center
or front.
□ Used with Equalizer
PROBLEM
POSSIBLE CAUSE
PROBABLE SOLUTION
Tonal quality remains
unchanged even if equalizer is
adjusted.
The adjusted sound is not
included in the cassette tape,
compact disk, or broadcast.
Change the cassette tape, com
pact disk, or broadcast, and
check again.
Only bass is output from the
rear speaker.
SBC-SW mode is selected.
Turn off SBC-SW mode.
Battery Replacement (Remote Control Unit)
1. Remove the battery holder.
Pull the holder by the Position B while pushing
Position A in the direction indicated by the
arrow.
2. Replace the battery.
Set a new battery properly with {+)side up
as illustrated.
3. Insert the battery holder.
Push in the holder to the original position.
Battery holder
Position B
Position A
Note on Batteries
Old batteries must immediately be removed and disposed.
Battery Information:
• Designated Battery: Panasonic Lithium Battery (CR2025)
• Battery Life: 6 months with normal use {in normal room temperature)
Caution:
Improper use of batteries may cause overheating, explosion or ignition, resulting in injury or fire.
Battery leakage may cause damage to the unit.
•
• Do not disassemble or short the batteries. Do not throw the batteries into the fire.
• To avoid the risk of accident, keep the batteries out of reach of children.
CQ-VX777EUC
57