Cautions, Types of documents to avoid for the adf, Loading documents on the adf – Panasonic HIGH SPEED KV-S6045W Manuel d'utilisation

Page 23

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

Loading Documents on the ADF

6

When using long paper, pull out
the hopper extension tray from

the hopper and the exit document

stopper from the document cover.

Then

adjust

the

exit

document

stopper

above

the

document

cover

a

little

longer

than

the

actual length of the document by

pressing down the exit document

stopper slightly. (See fig. 1.)

• When scanning narrow documents as

shown

below,

pull

up

the

exit

substopper. (See fig. 2.)
After using the exit substopper, push

down it.

Scanning direction

Document

Hopper

Hopper extension

tray

Document cover

Exit document stopper

Fig. 1

Cautions:

• When scanning very fragile documents, scan with the flatbed side. (See page 24.)
• For thin, thick or important paper, scan the document with the flatbed side or using single sheet (manual

feed) mode. Also, remove the document from the document cover after it is scanned by the ADF.

• The scanner will accept 50 to 127 g/rn (13 to 34 lbs.) paper for continuous scanning and 40 to 127 g/rrf

(10.6 to 34 lbs.) paper for single scanning.

• When scanning a thin, folded, creased or curled document by the ADF, after straightening the document,

set the feed speed to "Slow".

• When scanning thick documents [ 6 4 g / m (17 lbs.) or more] , be sure to use less than 200 sheets.
• When scanning copying paper such as carbon or carbonless paper, use the flatbed.
• When setting the document, be sure that it does not exceed the fill indicator (limit mark).
• Be sure to remove the document from the document cover after it is scanned.
• When the scanner does not detect a document set in the hopper which has a black or dark area on the

opposite side, add a white sheet of paper under the document.

• When scanning the different sized documents, exited document may go into the stack of documents on the

exit part and may get out of order.

Types of documents to avoid for the A D F :

• OHP sheets, other plastic film, cloth, or metallic sheets
• Paper with irregularities such as tabs, staples, paste, etc.
• Documents with wet ink
• Thick or irregular documents such as envelopes, paste, etc.
• Copying paper such as carbons or carbonless paper (Chemically treated carbonless forms)

Note: Scanning chemically treated paper will result in premature wear of the paper feed roller.

• Damaged or wrinkled documents
• Unusually shaped documents
• Tracing paper

23

Advertising
Ce manuel est liée aux produits suivants: