Panasonic HIGH SPEED KV-S6045W - Manuel (Page 18)

Display Panel Instructions
"Others" setting menu (by pressing the OTHERS key)
Number, mode and default display
• Pressing the ▲ key will change to the
next mode.
• Pressing the ▼ key will change to the
previous mode.
Contents
• Pressing the ► key or the *4 key will change to another
value.
01 Checking the Rrmware Version
Г И Х . Х X : Displays the mechanical control firmware
version.
F x . x X : Displays the imprinter firmware version.
If a imprinter unit is not installed, the entry will
remain blank.
0 1 V e r s i о n
M X X X F X X X
02 Setting the "Buzzer"
pON OFF 0 2 В u z z e r
0 N
03 Setting the SCSI ID
0 3 S C S 1 1 D 1 • Setting the SCSI ID will be activated after turning the
power off and turning it on again. N о . 1 0
04 Setting the "Terminator"
pDisable Enable-<-j
0 4 . T e г m i n a t 0 r
When the scanner is located to terminal position on SCSI
bus, set to "Enable".
• Setting the terminator will be activated after turning the
power off and turning it on again.
1 D i s a b 1 e
05 Checking the "Roller Cleaning
Warning"
0% : This is displayed when "Clean Roller Warning
00%" displayed is cleared.
100% : This is displayed when the roller needs to be
cleaned.
0 5 c 1 e a n R 0 1 1 e г
w a r n i n 9 0 %
05 Clearing the "Roller Cleaning
Warning"
When pressing the ► key and the -4 key simultaneously,
"Clean Roller Warning" will be cleared. Then "Completed"
will be displayed.
0 5 c 1 e a n R о 1 1 e r
w a r n i n C 1 e 1 a r — < >
06 Checking the roller modules
replacement warning
0% : This is displayed when "Replace Roll. Warning
00% " displayed is cleared.
100% : This is displayed when the roller modules need to
be replaced.
0 6 R e P i a c e R o l 1 1
w a r n i n 0 %
06 Clearing the roller modules
replacement warning
When pressing the ► key and the M key simultaneously,
"Replace Roll. Warning" will be cleared. Then "Completed"
will be displayed. 0 6 R e P 1 a c e R о 1 I
w a г n i n 9 C 1 e a г = < >
18