Panasonic CF-37 Series - Manuel (Page 18)

List of Error Codes
18
02F5: DMA Test Failed
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers,
02F6: Software NMI Failed
ServcrBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).
02F7; Fail - Safe Timer NMI Failed
ServerBIOS2 test error: Fail-Safe Timer takes too long.
device address Conflict
Address conflict for specified device.
Allocation Error for: device
Run ISA or FISA Conllguration Utility to resolve resource contlict for the specified device.
CD ROM Drive
CD ROM Drive identified.
Entering SETUP...
Starting Setup Utility.
Failing Bits : tinnn
The hex number nniin is a map of the bits at the RAM address which failed the memory test. Each I (one) in the map
indicates a failed bit. See error 230,231 or 232 for offset addre.ss of the failure in System. Extended or Shadow
memory.
Fixed Disk n
Fixed disk n (0-3) identified.
Invalid System Configuration Data
Problem with NVRAM (CMOS) data,
I/O device IRQ conflict
I/O device IRQ eonlliet error.
PS/2 Mouse Boot Summary Screen:
PS/2 Mouse installed.
nnnn кВ Extended RAM Pa.ssed
Where iinnn is the amount of RAM in kilobytes successfully tested.
nnnn Cache SRAM Passed
Where nrmn is the amount of system cache in kilobytc,s successfully tested.
nnnn кВ Shadow RAM Passed
Where nnnn is the amount of shadow RAM in kilobytes successfully tested.
nnnn кВ System RAM Passed
Where nnnn is the amount of system RAM in kilobytes successfully tested.
Operating Sy.stem not found
Operating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed disk and drive A: arc
properly identified.
Parity Check I nnnn
Parity error found in the system bus, BIOS attempts to locale the address and display it on the screen. If it cannot
locate the address, it displays ??7?. Parity is a method for checking errors in binary data. A parity error indicates that
some data has been corrupted.
Parity Check 2 nnnn
Parity error found in the I/O bus. BIOS attempts to locate the address and display it on the .screen. If it cannot locate
the address, it displays ????.
Pre.ss <FI> to resume, <F2> to Setup, <F3> for previous
Displayed after any recoverable error message. Press <F1> to start the boot process or <F2> lo enter a Setup and
change the settings. Press <F3> to display the previous screen (usually an initialization error of an Option ROM. l.e„
an add-on card). Write down and follow the information shown on the screen.
Press <F2> to enter Setup
Optional message displayed during POST, Can be turned off in Setup.
PS/2 Mouse:
PS/2 mouse identified.
System BIOS shadowed
System BIOS copied to shadow RAM.
UMB upper limit segment address : nnnn
Displays the address nnnn of the upper limit of Upper Memory Blocks, indicating released segments of the BIOS
which can be reclaimed by a virtual memory manager.
Video BIOS shadowed
Video BIOS successfully copied to shadow RAM.