Installation of auto iris lens connector – Panasonic CCTV CAMERAS WV-BP132 Manuel d'utilisation
Page 12
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Installation of Auto Iris Lens Connector
Install the lens connector (YFE4191J100) when using a
video drive ALC lens.
The installation should be made by qualified ser
vice personnel or system installers.
(1) Cut the iris control cable at the edge of the lens
connector to remove the existing lens connector
and then remove the outer cable cover as shown
in the diagram below.
The pin assignment of the lens connector is as fol
lows:
Pin 1: Power source; +9V DC, 50mA max.
Pin 2: Not used
Pin 3: Video signal; 0.7 V[p-p]/40 k£2
Pin 4: Shield, ground
Pin 4
(2) After connection, assemble the lens connector as
follows.
Note: When the iris control cable is too thick to
lock the connector cover with the connector
base, cut off the rib on the connector.
(Set the lens type and drive signal selector to
the VIDEO position.) -
-
10
-