Panasonic CY-M7002EUC - Manuel (Page 5)

Level Adjust Volume
(Front side of the unit)
(See page 4)
GAIN
Low
Output
Level
■ Level Adjustment O:
In some instances, the acoustical output from each speaker may not be
balanced properly depending upon the type of speakers or tape
player/radio unit to be used If this occurs, try to adjust the volume level
by turning the level adjust volume to the left or right until the output from
each amplifier is balanced by using a flat-head screwdriver as shown in
the illustration
At first, the level is set at -3dB against the maximum level
■ Mode Selection:
This mode selector switch @ has two positions and they are
explained as follows For speaker connection, refer to page 7 Caution: Before switching the mode selec­
tor or making speaker connections, the
power to the unit must be switched off
Mode Selection Switch
MONO ST
• •
PB I
■ Sub-woofer Cutoff Frequency Switching " "
The cutoff frequency of subwoofer output can be changed as follows using this switch 0
• OFF : The cutoff frequency circuit is opened to return to normal frequency response
• 80Hz LPF : The cutoff frequency of subwoofer output is set to 80 Hz
• 120Hz LPF : The cutoff frequency of subwoofer output is set to 120 Hz
Position Mode Output Power
ST STEREO 7 0 W x 2
MONO MONAURAL 150W
System Diagram
■ Use this unit with Panasonic car audio products for best results
■ Various types of speakers are available from your nearest authonzed dealer
Select the speakers that are suitable for your system’s requirement
Standard Example (At ST Mode):
Front Speaker
(Right)
Front Speaker
(Left)
Rear Speaker
(Right)
Rear Speaker
(Left)
Front Speaker
(Right)
Front Speaker
(Left)
Rear Speaker
(Right)
Rear Speaker
(Left)
Sub-Woofe
Speaker
CY-M7002EUC