Stop bit, Wait time, Network setup – Panasonic WJ-HD500 Manuel d'utilisation

Page 65

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

• Stop Bit

This item lets you set the number of stop bits for RS-232C
communication.

1. Move the cursor to the STOP BIT parameter by press­

ing the

A

or

T

button.

2. Select either 1 or 2 for the number of stop bits by press­

ing the (±) or 0 button.

The factory default setting is 1 bit.

• Wait Time

This item lets you set the waiting time in milli-seconds (ms)

to retry after confirming that no data is received from the
controller for RS-232C communication.

1. Move the cursor to the WAIT TIME parameter by press­

ing the

A

or

T

button.

2. Select OFF, 100, 200, 400, 1 000 ms for the wait time by

pressing the 0 or 0 button.

When no transmission is needed, select OFF.

The factory default setting is OFF (no retry).

Network Setup

When the optional Network Board is installed in the Disk

Recorder, the Disk Recorder can be controlled from a

Client PC via the Ethernet Hub.
These items let you set the parameters for communication

between the 10/100BASE-T port of the Disk Recorder and

outboard device via Ethernet.

1. Move the cursor to IP ADDRESS in the COMMUNICA­

TION SETUP menu by pressing the

T

or

A

button,

then press the

SET

button.

The cursor moves to the right editing area.

2. Select the value for the IP Address by pressing the 0

or 0 button.

3. Move the cursor to the right by pressing the ► button,

then select the value for the IP Address by pressing the

s

or

s

button.

4. Repeat the above steps 2 and 3 until the IP Address is

completed.

5. When the IP Address is completed, press the

SETUP/ESC

button to return the cursor to IP ADDRESS

in the menu.

6. Similarly repeat the above steps 1 to 5 to set the

Netmask and Gateway.

7. To return to the previous setup menu, press the

SETUP/ESC

button

66

Advertising